Samson TM300 owner manual Guided Tour Rear Panel, Samson

Page 11

Guided Tour - Rear Panel

TM300 6 CHANNEL 150WATT STEREO MIXER

SAMSON

CAUTION

SERIAL NUMBER

RISK OF ELECTRIC SHOCK

 

DO NOT OPEN

 

 

AVIS;

CAUTION: TO REDUCE THE

 

RISQUE DE CHOC ELECTRIQUE

RISK OF FIRE, REPLACE ONLY

 

NE PAS OUVRIR

 

DO NOT EXPOSE THIS EQUIPMENT

WITH SAME TYPE FUSE.

 

TO RAIN OR MOISTURE.

 

 

 

 

FUSE

 

 

 

 

8A/250V(115V)

 

 

4A/250V(230V)

 

 

AC INPUT

 

 

115V/230V,50/60Hz

 

 

780W

 

 

 

 

POWER

ON

OFF

SPEAKER

OUT

RL

CAUTION:

DO NOT BLOCK AIRFLOW

USE CLASS 2 WIRING

MINIMUM LOAD

IMPEDANCE 4Ω

ENGLISH

1

 

2

 

3

 

4

 

5

 

6

 

 

 

 

 

 

 

 

 

 

 

1:Vent - To ensure proper cooling of the TM300 power amplifier, make sure this vent is unobstructed at all times.

2:Fuse holder - Holds an 8 A / 250 V fuse for 115 volt operation or a 4 A / 250 V fuse for 230 volt operation

3:AC input - Connect the supplied heavy gauge 3-pin “IEC” power cable here.

4:Speaker Outputs - These are the TM300’s main outputs; use these four unbalanced jacks (two of which carry the left signal and two of which carry the right) to connect the TM300 to loudspeakers rated at 4 ohms or greater (that is, 4, 8, or 16 ohms). The lower the ohm rating, the greater the power output. We recommend the use of 4 ohm speakers for long-term usage. The TM300 delivers 150 watts of power per channel into 4 ohms at less than 1% THD (Total Harmonic Distortion). In order to ensure correct phase correlation, the tip of the TM300 speaker jack should be connected to the “+” (hot) input of your loudspeaker, and the sleeve of the TM300 speaker jack should be connected to the “-” (ground) input of your loudspeaker. Note that, when the Aux 1 / Monitor switch (see # 19 on page 8) is pressed in, the TM300 operates in a “split mono” configuration, where the left speaker output carries the main stereo output (internally mixed to mono) and the right speaker output carries Aux send 1.

5:Power on-off switch - As you may have guessed, this is what you use to turn the TM300 on and off. If the TM300 is connected to external power amps (via its Main Insert and/or Mono output jacks— see #4 and #5 on page 6 in this manual), turn it on before you turn on the connected amps— and turn it off after the connected amps are turned off.

6:Fan - This variable-speed fan provides vital cooling to your TM300 power amp

(the hotter the amp gets, the faster the fan blows!). Make sure that cool, fresh air is accessible at all times. Also, try to ensure that the TM300 is used in a dust-free environment.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents TM300 Table of Contents TM300 Features Introduction / TM300 FeaturesTM300 Features Guided Tour Overview Guided Tour Channels Guided Tour Channels Samson Guided Tour Main SectionGuided Tour Main Section Guided Tour Main Section Samson Guided Tour Rear PanelSignal Ground T to MIC + Signal Connecting the TM300TM300 Interconnections Stereo Configuration TM300 Interconnections Split Mono Configuration Setting Up and Using The TM300 Setting the Correct Gain Structure Setting the Correct Gain Structure Grounding Techniques Using Equalization Seven-band graphic master equalizer Using Pan Using Aux Sends and Returns Using Inserts Using the Internal Digital Signal Processor DSP Caractéristiques Techniques Introduction/caractéristiques du TMCaractéristiques Techniques du TM300 Visite Guidée Les voies Visite Guidée Les voies Entré e Tape In G, D Connectez les Visite guidée Section principaleVisite guidée Section principale Visite guidée Section principale Visite guidée Face arrière Installation et utilisation du TM300 Réglages de gain Réglages de gain Deutsche Einleitung / TM300 MerkmaleTM300 Merkmale Überblick die Kanäle Überblick die Kanäle Tape In Eingang L,R Verbinden Sie die Übersicht HauptabschnittÜbersicht Hauptabschnitt Übersicht Hauptabschnitt Übersicht Rückseite Einstellung und Bedienung des TM300 Einstellung der Gain-Struktur Einstellung der Gain-Struktur Características de la TM300 Introducción / Características de la TM300Características de la TM300 Recorrido guiado Canales Recorrido guiado Canales Entrada de cinta L, R Conecte las Recorrido guiado Sección principalRecorrido guiado Sección principal Recorrido guiado Sección principal Samsonon Recorrido guiado Panel traseroAjuste y uso de la TM300 Ajuste de la estructura de ganancia correcta Ajuste de la estructura de ganancia correcta Maximum Voltage Gain Specifications

TM300 specifications

The Samson TM300 is a highly regarded professional microphone designed for studio and live performance applications. Renowned for its distinctive sound quality and durability, the TM300 caters to musicians, vocalists, and audio engineers alike.

At the core of the TM300's design is its dynamic microphone element, which excels in capturing the nuances of vocal performances. This type of microphone inherently rejects unwanted noise and feedback, making it an excellent choice for both live settings and studio recordings. The TM300's frequency response, typically spanning from 50Hz to 15kHz, showcases its ability to reproduce deep lows and crisp highs, ensuring that every vocal nuance is accurately captured.

One of the standout features of the TM300 is its cardioid polar pattern. This directional pickup pattern allows the microphone to focus on sound sources directly in front of it while minimizing background noise from the sides and rear. This characteristic is crucial in live settings, where minimizing ambient noise can greatly enhance the clarity of the performance.

The TM300 is built with high-quality materials, featuring a rugged metal housing that can withstand the rigors of frequent use. Its sturdy construction ensures longevity, even in demanding environments. Furthermore, the microphone includes a built-in pop filter that helps reduce plosive sounds (such as "p" and "b" consonants), providing cleaner audio capture without the need for additional accessories.

In terms of connectivity, the Samson TM300 typically utilizes a standard XLR output, making it compatible with a wide range of mixing consoles, audio interfaces, and recording devices. This versatility allows it to be seamlessly integrated into both professional and home studio setups.

For audio professionals seeking an affordable yet high-performance microphone, the Samson TM300 offers exceptional sound quality, rugged build, and user-friendly features. Whether used for live performances, studio recordings, or broadcast applications, the TM300 continues to impress with its reliable performance, making it a favorite choice among musicians and audio engineers alike. As the demand for quality audio equipment rises, the TM300 remains a testament to Samson's commitment to excellence in the audio industry.
Top Page Image Contents