Samson C01 manual Using the Optional SP01 Shock-Mount, Using the Optional SP01 Spider Shock-Mount

Page 7

Using the Optional SP01 Shock-Mount

Using the Optional SP01 “Spider” Shock-Mount

For additional isolation the C01 can be fit- ted on the optional SP01 “Spider” shock mount. Follow the steps below the to install the SP01.

•First, screw the SP01 shock mount onto your mic stand or boom arm. If you’re using a US 5/8” mic stand or boom, remove the Euro adapter.

•Remove the C01 swivel mount by rotating the threaded collar counter- clockwise as shown in figure 1.

•Install the C01 into the SP01 by fitting the microphone into the center of the web, positioning the C01 onto the bot- tom mounting plate.

•Secure the SP01 by reinstalling the threaded collar, rotating clockwise until tight. (Figure 2)

•Now, loosen the thumb screw to adjust the angle of the microphone and position the C01 to the desired location. Once set, tighten the thumb- screw to secure the microphone in place.

Note: Be careful not to cross thread or over tighten the threaded collar or thumb screw.

1

2

THREADED

COLLAR

SP01

SHOCK MOUNT

THUMB

SCREW

THREADED

COLLAR

ENGLISH

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents O F E S S I O N a L M I C R O P H O N E S Table Of Contents Introduction C01 Features Polar Pattern Powering the C01Microphone Placement Operating the C01Popping Setting Up the Signal LevelStand Mounting the C01 Using the Optional SP01 Spider Shock-Mount Using the Optional SP01 Shock-MountFrançais Présentation du C01 Directivité Placement du microUtilisation du C01 Mise sous tension du C01Installation du C01 sur un pied Réglage du niveau du signalBruits de pop Suspension anti-choc SP01 optionnelle Einleitung C01 Features Mikrofonplatzierung C01 bedienenC01 mit Spannung versorgen RichtcharakteristikPop-Geräusche Signalpegel einstellenStändermontage des C01 Optionalen SP01 SpiderAnti-Shock verwenden Optionalen SP01 Anti-Schock verwendenIntroducción EspañolFunciones y características del C01 Ubicación del micrófono Utilizar el C01Alimentación del C01 Patrón polarChasquido de P Ajustar el nivel de la señalInstalar el C01 en un pie Utilizar el aislante de golpes SP01 opcional Especificaciones del C01 C01 SpecificationsC01 Specifications C01 Technische Daten+20
Top Page Image Contents