DigiTech Complete Guide to Calibrating the Expression Pedal on 's Expression Factory
Page 31

Calibrating the Expression Pedal

If the Expression Pedal’s range becomes diminished over time, it may be necessary to re-calibrate the pedal. Here is the procedure for calibration:

1.Begin with the power disconnected from the Expression FactoryTM.

2.Select Model 1 using the MODEL knob.

3.Insert a standard mono (TS) guitar cable into the FOOTSWITCH jack.

4.Connect the power supply to the Expression Factory. The INDICA- TOR LED begins flashing green.

5.Rock the expression pedal forward (toe down).

6.Select Model 2 using the MODEL knob. The INDICATOR LED begins flashing yellow.

7.Rock the expression pedal back (toe up).

8.Select Model 3 using the Model knob. The INDICATOR LED should flash green three times if calibration was successful.

If the calibration procedure fails, the INDICATOR LED will flash red instead of green during step 8 and the unit will not return to normal operation until the Expression Pedal has been properly calibrated. Select Model 1 using the MODEL knob at this time and repeat steps 5-8 until Expression Pedal calibration is successful.

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Page Declaration of Conformity Page Included Items Setup Directions Expression FactoryTM Features at a Glance Page OUT 1 AMP Indicator LED Input Selecting and Enabling an Effect Model Model 1. Dunlop Cry BabyTM Model DescriptionsModel 2.Vox Clyde McCoyTM Wah Control 1 tip Pitch Shift Selects one Model 3. DigiTech XP300 Space StationTM Synth SwellTMWhammy Amount Model 4. DigiTech WhammyModel 5. Unicord Uni-VibeTM Model 6. Leslie 147 Rotary Speaker Model 7.A/DATM Flanger Effect Model Expression Control Pedal Effect Model Control TableSettings to GetYou Going Page Selecting and Activating a Distortion Model + Effect Model Page Distortion Model Cabinet Model Distortion and Cabinet ModelsFlexible Output ModeTM Connections Diagram Flexible Output Mode 1 Mono Connections Diagram Flexible Output Mode 2 Stereo Mixer Connections Diagram Flexible Output Mode 3 Stereo Amp Connections Diagram Flexible Output Mode 4 Amp + Mixer Flexible Output ModeTM Setup Calibrating the Expression Pedal Using the Optional FS3X Footswitch Down FS3X Footswitch OptionalPage Control 3/DIST GAIN, Model Specifications
Top Page Image Contents