Convenient Functions
Phrase Loop Play
You can record up to 38 seconds of a performance and play back the | 1. | Set the DELAY effect's TYPE knob to PHRASE LOOP. |
recorded section over and over. You can also layer additional |
| The unit goes into recording standby and the pedal's indicator flashes |
performances with the recording as it plays back (overdubbing). |
| at a fixed interval. |
This lets you create realtime backing performances on the fly. | 2. | Press the DELAY pedal. |
This section describes how to carry out the operation when in Manual mode.
When you're in Memory mode, you can accomplish the same operation by 3. using the number pedal for the currently selected patch.
|
|
| 4. |
Pedal | 1 | 2,3,6 | 5 |
Indicators | |||
1. |
| 2. | 5. |
| STANDBY |
| REC |
|
|
| 6. |
6. | 6. |
| 3. |
|
|
| |
|
| 4. | |
|
|
| |
| OVERDUB |
| PLAY |
Pedal |
|
|
|
Indicator |
| 4. |
|
Lit |
|
| |
|
|
| |
Dark |
|
|
|
Recording starts as soon as you press the DELAY pedal, and the pedal’s indicator flashes rapidly.
Press the DELAY pedal again.
Recording ends. As soon as recording stops, repeated playback of what's been recorded starts, and the pedal's indicator lights continuously.
An oscillating sound may be audible with extremely short recording times.
To layer additional recordings (overdubbing), repeat Steps 2 and 3.
When you switch the DELAY effect's TYPE knob to another position or turn the power off, the recorded data is deleted.
Adjust the phrase loop's volume as desired with the DELAY effect's E. LEVEL knob.
Press the pedal twice switch to stop the playback.
The unit returns to recording standby.
Press the DELAY pedal twice within the span of one second.
When playback ends, the recorded data is deleted.
English
Deutsch
Français
Italiano
Making the Settings for Control Operation
Español
When you call up patches or EZ Tones, an effect's parameters may not reflect the actual position of the control knobs. You can set how the parameters behave when the control knobs are moved in this state.
2 | 1 | 4 | 3 |
1.Press number pedals 3 and 4 at the same time to change to Manual mode (p.
2.Hold down [EDIT/EXIT] and press the COMP pedal.
3.Use NS THRES/BANK [ 
] or [ 
] to select the method of control operation.
Display | Control operation | |
n0 | The value changes immediately as the knob is | |
| turned (factory setting). | |
n1 | The value changes once the knob is turned past | |
| the position corresponding to the currently set | |
| value. | |
|
|
4.Press [WRITE].
The setting is stored in memory.
Português Nederlands