Roland Comprehensive ME-70 Manual: Restore Factory Settings and Adjust Expression Pedal

Restoring the Factory Settings (Factory Reset)

You can restore the settings in the ME-70 (User patch, tuner	1. Press number pedals 3 and 4 at the same time to
reference pitch, and knob response method (p. E-15)) to the values	switch to Manual mode (p. E-10).
set when the unit was shipped from the factory.

	2.	Hold down [EDIT/EXIT] press MOD Pedal.
	3, 4	“F” appears in the display.
	3.	Press [WRITE].
		The Tuning Guide flashes.
	4.	Press [WRITE] again.
		The display flashes and the factory reset is executed.
		Never turn off the power while Factory Reset is in progress.
2	1

Adjusting the Expression Pedal

The ME-70's expression pedal has been set for optimal operation at the factory. However, extended use and certain operating environments can result in the pedal going out of adjustment.

If you encounter problems such as the expression pedal's ON/OFF switch not functioning or the volume pedal not fully cutting off the sound, you can use the following procedure to readjust the pedal.

3,4,6			4
1	2	5	3

1.Press number pedals 3 and 4 at the same time to switch to Manual mode (p. E-10).

2.Hold down [EDIT/EXIT] press DELAY Pedal.

The display shows “Pd,” then “Up.”

3.Move the heel of the expression pedal all the way

down, then release the pedal and press [WRITE].

The display shows “dn.”

4.Move the toe of the expression pedal all the way

down, then release the pedal and press [WRITE].

A value indicating the current stiffness (sensitivity) of the expression pedal switch appears in the display.

If the display flashes in Steps 3 or 4, press the pedal again, and then press [WRITE].

5.Use NS THRES/BANK [ ] and [ ] to adjust the

stiffness (sensitivity) of the expression pedal switch.

The lower the value, the more easily the switch will respond, even when pressed lightly.

	This is set to “5” when shipped from the factory.
When operating the expression pedal, be careful not to get your fingers	6. Press [WRITE].
pinched between the movable part and the panel. In places with small children,	The setting is saved in memory.
an adult should provide supervision and guidance until the child is capable of
following all the rules essential for the safe operation of the unit.

E-16