Akai MPK88, MPK61 manual Program Change Parameters

Page 23

PROGRAM CHANGE PARAMETERS

The following list of parameters can be accessed if the button event type is set to “Program Change”.

MIDI CHANNEL FIELD

Program Change messages can be sent on one of two MIDI Ports, A or B, and one of 16 MIDI Channels on each port (i.e. A7). You may also assign Program Change to use the MIDI Common Channel.

1.Use the [<] button to select MIDI Port/Channel field.

2.While in MIDI Port/Channel field, use [VALUE] dial to select desired MIDI Port and Channel.

3.Use the [>] button to select the next field.

MIDI PORT/CHANNEL FIELD

PROGRAM CHANGE FIELD

In this field you can set which Program Change Number the button will transmit when it is pressed.

1.Use [<] or [>] buttons to select Program Change field.

2.While in Program Change field, use [VALUE] dial to select desired Program Change Number.

3.Use the [>] button to select the next field.

PORGRAM CHANGE FIELD

BANK M FIELD

Bank M describes the Most Significant Bit (MSB) of information.

1.Use [<] or [>] buttons to select Bank M field.

2.While in Bank M field, use [VALUE] dial to select desired value.

3.Use the [>] button to select the next field.

BANK M FIELD

BANK L FIELD

Bank L describes the Least Significant Bit (MSB) of information.

1.Use the [<] or [>] buttons to select Bank L field.

2.While in Bank L field, use [VALUE] dial to select desired value.

BANK L FIELD

Note:

You can also configure buttons to send Program Change messages only, without specifying Bank M and Bank L. While editing Bank M and Bank L fields of a button, use [VALUE] dial to set Bank M and Bank L to ‘OFF’ (beyond 000). This will cause the button to transmit only a Program Change message.

20

Image 23
Contents Operators Manual Page Table of Contents 6 7 8 Front Panel OverviewLevel When 16 Level Rear Panel Overview Hookup DiagramUSB cable not connected USB cable connectedOctave and Transposition Displaying InformationControl Aftertouch About Modes Preset ModeWhat is a Preset? Preset ModeNavigating Edit Mode Edit ModeController Selected Edit Mode ParametersKeyboard Velocity Editing the KeyboardKeyboard Octave Keyboard AftertouchEditing the Pads What is a Note Message ? What is a Program Change ?Pressure Behavior Play Mode FieldMidi Channel Field Bank L Field Program Change ParametersProgram Change Field Bank M FieldEditing Knobs and Faders What is Control Change?What is Aftertouch? Maximum Range Field Control Change ParametersControl Change Field Minimum Range FieldAftertouch Parameters INCREMENT/DECREMENT Parameters knobs only Editing Buttons Play ModeProgram Change Parameters Editing the Arpeggiator Range Arpeggio Parameters TYPE, RANGE, Button ModeButton Mode ARP TypeSwing Arpeggio Parameters GATE, SwingGate Please note Editing Note RepeatGate Field Editing Time Division Default Time DivisionEditing the Pitch Bend Wheel Minimum Value Editing the Modulation WheelMidi Channel Midi CCEditing TAP Tempo Editingmaximum Value Transport ControlEditing Footswitch Pedal Inputs Other Functions Editing Expression Pedal InputDrum PAD Parameters Split Parameters Editing SplitSplit Point Kill Midi Page1 Global ModeKeyboard Velocity Curve PAD Threshold SysEx transfers to the MPK61/MPK88 Save GlobalProg Change Program Change Program Change ModeFrequently Asked Questions Troubleshooting Email support@akaipro.com TEL 401.658.4032 U.S Technical Specifications51-0296-B