Power Acoustik power acoustik manual USB Port Power Indicator

USER’S GUIDE:

13

14

15

16

17

8

9

10

1USB PORT

2POWER INDICATOR

When the POWER SWITCH is turned on, and the line cord is connected to an active AC mains supply. This indicator is just located above the LINE OUTPUT, glows to let you know that you're ready to rock and roll. reduces the input signal. CLIP (LIMIT) led lights whenever the limit circuit is active.

It's okay for CLIP indicator to blink occasionally, but if it blinks frequently or continuously, either turn down the signal level at the mixer or other signal source, or turn down the machine

3MP3/IPOD SWITCH

4CLIP INDICATOR

When signal levels at the amplifier outputs approach clipping, a soft limiting circuit is activated

5MASTR VOLUME

6MP3/IPOD VOLUME CONTROL

7MIC/LINE SWITCH

A combination XLR and 1/4” TRS connector, and accepts balanced or unbalanced line-level signals from mixers, preamplifiers, CD players, tape decks.ect, with the MIC/LINE SWITCH out; and accepts direct connections from dynamic microphones with the MIC/LINE SWITCH pushed in.

8TAPE/CD INPUT( STEREO INPUT)

Channel 2 has a pair of RCA connectors, which accept a stereo line-level input from a CD player or TAPE player (or any other line-level device)

9LINE OUT

These speakers has both XLR and 1/4” TRS connectors.

Use these connectors to patch the signal to another active speakers.

10POWER SWITCH

Switch up to turn the machines on. Make sure the VOLUME control is down before you turn it on.

When the POWER SWITCH is turned on, and the line cord is connected to an active AC main supply. The cool blue led on the back of the speaker glows to let you know that you're ready to rock and roll.

7