Pioneer S-DV353, S-DV555T, S-DV1SW, HTZ353DVD Getting started, Using the on-screen displays, Menu

02Getting started

1Connect the microphone to the MCACC MIC jack on the rear panel.

ANTENNA			CR/
		COMPONENT	PR
		VIDEO
		VIDEO	CB/
	FM		PB
AM LOOP	UNBAL75Ω
	IN	S-VIDEO	Y
MCACC		VIDEO OUT
MIC	CONTROL

2Place the microphone at your normal listening position.

Place it about ear height, and make sure it is level by using a table or chair.

Make sure there are no obstacles between the speakers and the microphone.

3If the system is off, press STANDBY/ON to turn the power on.

If the tuner is selected, switch the input source.

4Press SHIFT+MCACC.

Try to be as quiet as possible after pressing SHIFT+MCACC. The volume increases automatically and the system outputs a series of test tones.

•Press SHIFT+MCACC to cancel and revert to the previous Auto MCACC settings.

•If the noise level is too high, NOISY blinks in the display for five seconds. To exit and check the noise levels1, press SHIFT+MCACC, or to try again, press ENTER when RETRY shows in the display.

When the MCACC setup is complete, the volume level returns to normal and

COMPLETE3 shows in the display, indicating that the MCACC setup is complete and

Acoustic Calibration EQ has been activated.4

Using the on-screen displays

For ease of use, this system makes extensive use of graphical on-screen displays (OSDs).

All the screens are navigated in basically the same way, using , , , to change the highlighted item and pressing ENTER to select

it.5

Important

•Throughout this manual, ‘Select’ means use the cursor buttons to highlight an item on-screen, then press ENTER.

Button What it does

HOME Displays/exits the on-screen display

MENU

Changes the highlighted menu item

ENTER Selects the highlighted menu item

RETURN Returns to the main menu without saving changes

•If you see an ERR MIC or ERR SP message in the display, there may be a problem with your mic or the speaker connections. To try again, press ENTER when you see RETRY2.

Tip

•The button guide at the bottom of every OSD screen shows you which buttons you’ll need to use for that screen.

Note

1• If the room environment is not optimal for the Auto MCACC setup (too much ambient noise, echo off the walls, obstacles blocking the speakers from the microphone) the final settings may be incorrect. Check for household appliances (air condition- er, fridge, fan, etc.), that may be affecting the environment and switch them off if necessary.

•Some older TVs may interfere with the operation of the mic. If this seems to be happening, switch off the TV during the Auto MCACC setup.

2If this doesn’t work, press SHIFT+MCACC, turn off the power, and check the problem indicated by the ERR message, then try the Auto MCACC setup again.

3If COMPLETE doesn’t appear, it is likely an error occurred during the setup. Please check all connections and try again.

4See Listening with Acoustic Calibration EQ on page 15 to switch on/off Acoustic Calibration EQ.

5The screen saver will appear after five minutes of inactivity.

10

En