SETUP
Power
Your product is equipped with
| setting. |
Warning! | Verify that the power select switch on your unit |
| matches the line voltage applied. All fixtures must be |
| connected to circuits with a suitable Earth Ground. |
Slide switch up or down depending on your line voltage.
•To determine the power requirements for a particular fixture, see the label affixed to the back plate of the fixture or refer to the fixture’s specifications chart.
•A fixture’s listed current rating is its average current draw under normal conditions.
•All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100% switch.
•Before applying power to a fixture, check that the source voltage matches the fixture’s requirement.
•All fixtures must be connected to circuits with a suitable Earth Ground.
Mounting
ORIENTATION
This fixture may be mounted in any position provided there is adequate room for ventilation. It is also possible to stand this fixture using the removable feet provided.
RIGGING
It is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After finding the desired position, retighten both knobs.
•When selecting installation location, take into consideration lamp replacement access and routine maintenance.
•Safety cables should always be used.
•Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes or restricted ventilation.
Figure 2 - Hanging Clamp
Note!
Clamp is sold separately.
5 |