Pioneer VSX-36TX, VSX-37TX manual Remote Control of Other Components, Setup

Remote Control of Other Components

Setting Up the Remote Control to Control Other Components

In addition to controlling the receiver, the supplied remote control can operate your other components (VCR, TV, LD, CD, etc.) after you program it to do so. In this way, instead of fumbling with many different controls and buttons, you only need to use one remote control. If your component(s) are listed in the remote control's memory, simply follow the steps below. If your component(s) are not listed, or if you want the remote to learn additional operations, you can use the learning mode to input the information from the remote controls supplied with your other components.

Recalling Preset Codes

The following steps show you how to recall preset codes stored in the remote control. Once a preset code is recalled and the component assigned, you can use this remote to easily operate the component. See “Preset Code List“ on page 85 for the components and manufacturers available.

3

2,3

S0URCE		USE	RECEIVER	1	1	Set the remote control slide switch to
ë￿			SETUP
	MULTI	SYSTEM				SETUP.
	OPERATION	OFF
DVD/LD	TV/SAT	VCR1	VCR2
CD	MULTI CONTROL		TVCONT			Also make sure that your TV is on and set to the receiver.
	TAPE1	TUNER
	MD/
CLASS	MPX	BAND	DIRECT ACCESS
¦￿	7	3	8		2 Press the REMOTE SETUP (INPUT ATT)
1 Á￿		4 ¢
- TUNING +		- STATION +
DTV ON/OFF	DTV MENU	- CHANNEL +				button.
1	2		3
4	5		6			The REMOTE SET UP menu appears on your TV screen.
7	8		9
GUIDE	0		EXIT			Select Remote
			ENTER
+10			DISC			Setup Mode
+	TV		+			Remote SETUP+1
TV VOL	TV CONTROL		VOLUME			Preset Recall
–	TV FUNC		–			Remote SETUP+2
						Learning
REMOTE SETUP	MENU		MUTE			Remote SETUP+3
ATT						Multi-Operation
INPUT
SYSTEM SETUP						Remote SETUP+4
EFFECT/	+		FUNCTION			Direct Function
CH SEL

ENTER

DIGITAL	–		SIGNAL	You have four setup options:
NR			SELECT
	MULTI CH		STEREO/
MIDNIGHT		DSP
LIGHT	INPUT	ADVANCED	DIRECT	1 Preset Recall
	THX		STANDARD
		/DTS

2Learning

3Multi Operation (See p.71)

AV PRE-PROGRAMMED AND LEARNING	4 Direct Function (See p.74)
REMOTE CONTROL UNIT

Preset Recall and Learning are the two modes that teach the remote control to operate your other components. It's easiest to start with Preset Recall and, if setup isn't possible for certain components, move on to the Learning mode.

3Press the REMOTE SETUP button and 1 at the same time to select the preset recall

setup mode.

All the MULTI CONTROL buttons (except the TUNER button) start to blink.

To cancel the preset recall setup mode press REMOTE SET UP.

58