
09Additional information
Use in an excessively dusty or damp environment.
Place directly on top of an amplifier, or other component in your stereo system that becomes hot in use.
Use near a television or monitor as you may experience interferenceÑespecially if the television uses an indoor antenna.
Use in a kitchen or other room where the system may be exposed to smoke or steam.
Use on a thick rug or carpet, or cover with clothÑthis may prevent proper cooling of the system unit.
Place on an unstable surface, or one that is not large enough to support all four of the system unitÕs feet.
Glossary
Dolby Digital | A |
| system developed by Dolby |
| Laboratories that enables far more |
| audio to be stored on a disc than |
| PCM encoding. |
Dolby | A matrix decoding technology |
Pro Logic II | developed by Dolby Laboratories that |
| expands any |
| audio, such as CDs and TV |
| broadcasts, to a |
| playback (left/center/right/left |
| surround/right surround), resulting |
| in a surround experience. |
DTS | A |
| system developed by Digital Theater |
| Systems that enables far more audio |
| to be stored on a disc than PCM |
| encoding. |
Manufactured under license from Dolby Laboratories. “Dolby”, “Pro Logic” and the
“DTS” and “DTS Digital Surround” are registered trademarks of Digital Theater Systems, Inc.
The Windows logo, Windows Media, Xbox 360 and the Xbox logos are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries and are used under license from Microsoft.
30
Setting up the remote to control your
TV
You can use the supplied remote to control your TV. To be able to use this feature you first have to program the remote with a maker code from the table on the following page.
ENTER
PAUSE
LIVEBACKTV
CHANNEL –
PREV NEXT VOLUME
AUDIO |
| ANGLE | PLAY MODE |
|
| TIMER REC | REC MODE |
SETUP | /TUNE+ | SR+ ONETOUCHCOPY | |
/ST– | ENTER | /ST+ | MENU |
SOUND | /TUNE– TEST TONE | SLEEP | |
SURROUND | ADVANCED |
| TV/DVD |
| 0 |
|
|
TV CONTROL | JUKE BOX | ||
| + | + |
|
INPUT | CHANNEL | VOLUME | DISPLAY |
| – | – |
|
RDS DISP
1Switch on your TV.
2Press and hold down the BACK button, then enter the maker code for your TV.
The following table shows which buttons on the remote correspond to which numbers.
Number | Remote | Number | Remote button | |
button | ||||
|
|
| ||
1 | SETUP | 6 | ST+ | |
|
|
|
| |
2 | TUNE+ | 7 | SOUND | |
|
|
|
| |
3 | SR+ | 8 | TUNE– | |
|
|
|
| |
4 | ST– | 9 | TEST TONE | |
|
|
|
| |
5 | ENTER | 0 | SLEEP | |
|
|
|
|
See the table on the next page for the list of maker codes. If there is more than one code given for your maker, input the first one in the list.
¥If the makerÕs name of your TV doesnÕt appear in the table, you will not be able to use this remote to control your TV.
3 Point the remote towards your TV and press TV to check that the remote works with your TV.
If the remote is set up correctly, the TV should switch off. If it doesnÕt and there is another code given for your maker, repeat step 2 with a new code.
En