Service, Disassembly, Vac Operation

SERVICE

WARNING:

Voltages in this equipment are hazardous to life.

Refer servicing to qualified personnel.

Disassembly

The FP42 can be disassembled as follows. Remove four screws securing the cover assembly to the chassis. Carefully lift the cover assembly up and away from the chassis, taking care not to snag any wire leads or components. (It is not necessary to remove the end caps from the cover for access to the chassis.)

240 Vac Operation

To change the FP42 operating voltage from 120 Vac to 240 Vac, fol- low these steps.

1.	Locate the Power board.
2.	Remove the jumper plug from connector J205 (marked
	120V), and carefully insert it in connector J206 (marked
	240V), making sure all six pins are properly engaged.
3.	Insert the T50mA/250V fuse (packaged with the FP42) in
	the fuseholder marked F202.
4.	Replace the ac line cord (if necessry) with one designed for
	the 240-volt source. If the FP42 is to be used outside the
	U.S. and Canada, local regulations may require replacing
	the line cord with one having wire insulation colors as
	follows:

		“Live” or “Hot”	Neutral	Earth or
		“Live” or “Hot”	Neutral	Ground
				Ground

	U.S., Canada	Black	White	Green

	Europe	Brown	Blue	Green/Yellow

5.	Mark the FP42 rear panel with the new operating voltage.

Limiter Threshold Adjustment

To adjust the limiter threshold for a value different from the supplied

+14 dBm:

1.Connect a 600-ohm load and an ac voltmeter in parallel across one of the Output connectors. Set the Output Mic/ Line switch to Line.

2.Turn on the Tone Oscillator switch.

3.With the Limiter switch set to Out, adjust the Master Level control (for the left or right output, as applicable) until the ac voltmeter reads the desired level. Turn the Master control for the opposite channel to 0.

4.With the Limiter switch set to In, adjust the Limiter Thresh- old trimmer (R381 or R390) for the left or right output, as applicable, until the level drops 0.5 dB.

5.Perform the same procedure for the second Output channel.

Program Monitor in Cue Mode

The cuing mode normally provides the Headphones jacks with the cued channel output only, removing the program material. To retain the program material at the Headphones jacks (at 10 dB below the uncued program level) while cuing one channel, solder a 470-ki- lohm, 5%, 1/4-watt resistor across points A–B and C–D (drain and source) of Headphones circuit FETs Q313 and Q314. For program level reduction greater than 10 dB, use the following resistor values:

Program Level Reduction	Resistor Value

20 dB	2 megohms

30 dB	6.8 megohms

40 dB	22 megohms.