Thank you for buying this Pioneer product. Please read through these operating instructions for proper assembly and use. After you have finished reading the instructions, put them away in a safe place for future reference.
Before you start
Before setting up your speaker system, we recommend reading the operating instructions for your system thor- oughly.
•Only use the screws supplied when fixing the speaker to the speaker stand.
•Do not place the stand on an unstable and/or sloping surface. The stand and speaker may fall and cause injury.
•Do not use with any speaker system other than the one for which the unit was designed. The stand may collapse and be damaged and/or the speaker may fall and cause injury.
•When moving the speaker and stand, first remove the speaker from the stand, and then move the stand, holding it by the two stems.
Installing the speaker stands
Place the stand on a stable, level surface; placing the stand on an unstable surface can be dangerous.
When placing the speaker, keep in mind that the tone is affected by the position of the speaker.
If the bass is insufficient, move the speaker closer to the wall. The richest bass sound is obtained when the speaker is right against the wall. If the bass is too powerful, producing a muffled tone, move the speaker away from the wall. Placing the speaker against a thick curtain may also be effective.
50 cm | 20 cm |
Assembling the speaker stands
Assemble the speaker stands as illustrated below. Please note that a flathead screwdriver will be necessary for assembly. The following illustration shows the fully assem- bled speaker stand:
| Screw holes |
Speaker support | for securing |
speaker | |
Stand stems |
|
Stand base
•Align the screw holes on the stand base and speaker support with the screw holes in the two stems, then insert the screws and tighten.
| Screws (Bind head, M6xL40) | |
Speaker |
| 40 mm |
support |
| |
|
| |
|
| Black |
|
| (SBA6054) |
| Please note that sunken | |
Stand | screw holes are provided | |
stems | in the speaker support. | |
Stand |
|
|
base |
|
|
| Screws (Bind head, M6xL40) | |
| Nut |
|
| Spike (SBA6053) | 40 mm |
| Spike base | Black |
| (SLA1057) | |
| (SBA6054) | |
|
| |
Adjust the position as necessary to obtain optimal sound from your system.
•Pioneer assumes no liability whatsoever for damages resulting from assembly, improper mounting, insuffi- cient reinforcement, misuse of the product, acts of nature, etc.
2
En
•Make sure you assemble the stand on a flat surface that is relatively soft (such as a carpet).
•Make sure the screws are inserted in the screw holes as shown above (with the screw head hidden) when securing the speaker. Improper setup could result in damage or injury if the speaker falls from the stand.