Precor S3-19 manual Install Hi/Lo Pulley Assembly

S3.19 Assembly and Maintenance Guide

6. Install Hi/Lo Pulley Assembly

Note: Ask for assistance to move the Hi/Lo Pulley Assembly and align the mounting holes.

A.Attach the Hi/Lo Pulley Assembly to the Rear Crossbar using

three 1¼-inch hex head bolts three flat washers

three spring washers three locknuts Wrench tighten.

B.Attach the Floor Plate using two ¾-inch buttonhead bolts two locknuts

Wrench tighten using a 6mm hex key.

C.Attach the Crossbrace to the Top Beam using two 4-inch hex head bolts

four radius washers two locknuts

D.Attach the Crossbrace to the Hi/Lo Pulley using one 2-inch hex head bolt

one washer one locknut

Wrench tighten all three fasteners that secure the Crossbrace.

	2 - 4" bolts	C	D	1 - 2" bolt
	4 - radius washers
				1 - washer
	2 - locknuts			1 - locknut
			Crossbrace
					Hi/Lo Pulley Assembly
			Rear
			Crossbar
					3 - 1¼" bolts
					A 3 - washers
					3 - spring washers
					3 - locknuts
					2 - ¾" buttonhead bolts
					B 2 - locknuts
					Floor Plate
1	2		3	4	5	6

page 18