S3.19 Assembly and Maintenance Guide

D.Disassemble and remove the top pulley and its fasteners on the Main Upright.

E.Install the Top Beam on the Rear and Main Uprights.

Note: If necessary, use a rubber mallet to align the mounting holes.

F.Secure the Top Beam to the Rear Upright using two 2¼-inch hex head bolts

four flat washers two locknuts

G.Secure the Top Beam to the Main Upright using two 4-inch hex head bolts

four radius washers two locknuts

Note: Make sure the radius washers lie flat against the Main Upright before wrench tightening.

H.Wrench tighten all bolts. Start with the fasteners that secure the Top Beam and follow the order of the assembled steps in reverse.

J.Replace the top pulley and finger tighten the fasteners.

 

Align Top Beam with

 

 

 

 

 

E uprights.

 

 

 

 

 

 

 

 

 

 

2 - 2¼" bolts

F

 

 

 

 

 

4 - washers

 

 

 

 

 

2 - locknuts

 

Top Beam

 

 

 

 

 

 

D

 

 

 

 

 

 

J

 

 

2 - 4" bolts

G

 

 

Rear

 

4 - radius washers

 

 

 

2 - locknuts

 

 

 

Upright

 

 

 

 

 

 

Main

 

 

 

 

 

 

Upright

 

 

 

 

 

1

2

3

4

5

6

 

Step 1. Assemble Main Structure, continued

page 10

Page 10
Image 10
Precor S3-19 manual Top Beam