S3.19 Assembly and Maintenance Guide
1. Cable Tension
If you experience any cable problems, take the following steps to reduce tension on the cables:
A.Remove the Weight Pin and set it aside.
B.If the Leg Press is attached, place the Support Arm in the upright
C.Check that the Press Arm rests lightly on the Bumper Pad and is positioned so it causes minimal tension in the cable. If necessary, rotate the Bumper Pad.
D.Adjust the threaded ends on the Single Floating Pulleys so the amount showing is the same on all both pulleys. Retighten the jam nuts.
Note: You may need to loosen the jam nuts before making adjustments.
E.Adjust the Weight Stack threaded end. Retighten the jam nuts.
CAUTION: For safety reasons, always make sure to turn the screw three to four full turns
so that the threads are engaged inside the Selector Stem or Floating Pulleys before tightening the jam nuts.
F.Replace the Weight Pin into the Weight Stack.
D |
|
|
|
| C |
|
|
|
|
| D |
|
|
|
| A |
|
|
|
|
| F |
|
Leg Press Support Arm |
|
|
|
|
|
B in upright position. |
|
|
|
|
|
|
|
| E |
|
|
1 | 2 | 3 | 4 | 5 | 6 |
Cable Adjustments and Maintenance, continued
page 32
