Precor S3-19 manual Bolt Washers J Locknut

S3.19 Assembly and Maintenance Guide

J.Feed the threaded end of the cable beneath the 3½-inch pulley at the base of the Hi/Lo Pulley and reattach it using

one 2-inch hex head bolt two flat washers

one locknut Wrench tighten.

K.Cut the wire ties securing the Single Floating Pulley to the Hi/Lo Pulley Assembly. Remove any cable twists or kinks.

L.Attach the threaded end of the Mid Pulley Cable to the Single Floating Pulley. Continue turning the screw three to four full turns to secure it inside the floating pulley housing.

M.Check all pulley fasteners and wrench tighten, if necessary.

K

L

1 - 2" bolt

2 - washers J

1 - locknut

1

2

3

4

5

6

Step 10. Install Mid Pulley Cable and Hi/Lo Pulley Connection, continued

page 26