Precor S3-19 manual Install Rollers and Seat Pads

S3.19 Assembly and Maintenance Guide

3. Install Rollers and Seat Pads

A.Attach the top roller pads using

one ½-inch x 3½-inch threaded shaft two ½-inch zinc bolts

two zinc flat washers

Wrench tighten using the 5mm hex key.

B.Attach the two Leg Extension Brackets using four ¾-inch zinc countersunk hex head bolts.

C.Install the 4½-inch threaded shaft support to the Leg Extension Bracket using

two ¾-inch zinc countersunk hex head bolts Wrench tighten using the 5mm hex key.

Note: Tighten the threaded shaft support fasteners before wrench tightening the Leg Extension Bracket fasteners.

D.Slide a 1-inch Spacer, Plastic Washer, and a Roller Pad onto one end of a Roller Pad Rod. Insert one Mushroom Cap to plug the end hole. If necessary, pound the Mushroom Cap in place using the rubber mallet.

E.Insert the Roller Pad Rod through the hole in the Leg Extension Arm.

F.Slide the remaining 1-inch Spacer, Plastic Washer, and Roller Pad on the other end of the Roller Pad Rod. Insert one Mushroom Cap to plug the end hole. If necessary, pound the Mushroom Cap in place using the rubber mallet.

					1 - ½" threaded shaft
				A 2 - ½" zinc bolts
					2 - zinc washers
		4 - ¾" zinc	B
		countersunk bolts
		1 - threaded shaft	C
		support
		2 - ¾" zinc
		countersunk bolts
					1" spacer
					Plastic Washer
					Roller Pad
				Roller
				Pad Rod
				D	Mushroom Cap
				E
				F
1	2	3	4	5	6

Step 3. Install Rollers and Seat Pads

page 12