Installing and Composition

Installation and Composition

Installation Instructions

* Don’t place the projector in the following conditions. It may cause malfunction or product damage.

Provide proper ventilation for this projector.

The projector is equipped with ventilation holes(intake) on the bottom and ventilation holes(exhaust) on the front. do not block or place anything near these holes, or internal heat build-up may occur, causing picture degradation or damage to the projector.

Never insert materials as paper into the lower of the projector.

Ensure good ventilation around the projector.

The distance between the projector and the ceiling or bottom should be more than 20cm/8 inches.

Place this projector in adequate temperature and humidity conditions.

Install this projector only in a location where adequate temperature and humidity is available. (refer p.47)

Don’t place the projector where it can be covered with dust.

This may cause overheating of the projector.

The projector is manufactured using high-precision technology. You may, however, see tiny black points and/or bright points (red, blue, or green) that continuously appear on the projector Screen. This is a nor- mal result of the manufacturing process and does not indicate a malfunction.

To display DTV programs, it is necessary to connect a DTV receiver (Set-top Box) and connect it to the projector.

If there is no input signal, the Menu will not be displayed on screen.

12

Page 12
Image 12
LG Electronics AN110W-JD, AN110B-JD owner manual Installation and Composition, Installation Instructions