Information
Replacing the Lamp
Turn off the projector and unplug the power cable. Carefully place the lens side down on a
1 cushioned surface that will protect the lens from damage.
(Allow the lamp to cool for 1 hour before replacing it.)
After lifting the lamp cover off, remove the two
3 retaining screws on the lamp case with a screw- driver or similar objects.
Bolt
5 Pullcase.out the handle slowly and remove the lamp
7 Tighten the screws you removed in step 3.
(Make sure it is fixed hardly.)
Remove the two retaining screws on the lamp
2 cover with a screwdriver or similar objects and then lift off the lamp cover.
Lamp case bolt
4 Lift up the fixed wire knob on the lamp.
Knob
6 Insert the new lamp gently into the correct position. Make sure it is inserted correctly.
Replace the lamp cover and tighten the cover
8 screws.
(If the lamp cover is open, the lamp indicator flashes green
and the projector is not turned on.)
Using and other lamp may cause damage to the projector or lamp.
Make sure the lamp cover is securely fastened. If the lamp cover is open, and the projector is not turned on. In this case, contact your service center after checking the lamp to fix well.
44
