Removing/Installing the Front Battery | . | |
| For this procedure, refer to FIGURE 1. |
|
Reverse this procedure to install the front battery.
1. Place the wheelchair in a well ventilated area where work can be performed without risking damage to carpeting or floor covering.
2.If necessary, elevate the seat to the up most position.
3.Verify the joystick On/Off switch is in the Off position and disconnect joystick cable (not shown). Refer to Disconnecting/ Connecting the Joysticks on page 89.
4.Remove the two thumb screws securing the front shroud/battery retention bracket to the wheelchair base frame.
5.Remove the front shroud/battery retention bracket from the wheelchair base frame.
6.Disconnect the front battery connector from the front connector of the battery cable.
7.Remove the front battery from the wheelchair base frame.
Front Battery
Connector
8 SETUP/MAINTENANCE
Wheelchair Base Frame
Front Connector of Battery of
Battery Cable Located Here
Front Battery |
|
Front Shroud/Battery | Mounting |
Retention Bracket | Screws |
FIGURE 1 Removing/Installing the Batteries
Part No 1163181 | 79 | Invacare® FDX® |
