5 WHEELCHAIR OPERATION
5.4MPJ+ Joystick Switches and Indicators
For this procedure, refer to FIGURE 5.
On/Off - Drive Select Toggle Switch
The drive select toggle switch is located on the left side, below the LCD. The drive select position is momentary, meaning that it will return to the neutral position after a selection is made.
This switch allows the operator to select the type of operation or performance which best suits a particular control need or situation. The DRIVE 1 program uses performance values which are independent of those used for the DRIVE 2 or 3 or 4 program. As an example, an operator may have a control need for spasticity in the morning and a very different need in the afternoon. DRIVE 1 can be programmed for higher speeds and quicker response while DRIVE 2 can be programmed for slower speeds and less responsiveness or vise versa. The other two drive programs could be indoor and outdoor versions of DRIVE 1 and DRIVE 2.
Selecting the Drive Mode | Charger/Programming | Memory Card Slot | ||
1. | Move the toggle up and release. DRIVE 1 will appear on LCD. | |||
Input (Front of Joystick) |
| |||
2. | Move the toggle up and release again. DRIVE 2 will appear on LCD. |
| LCD Display | |
3. | Move the toggle up and release again. DRIVE 3 will appear on LCD. | Drive Select | Mode Switch | |
4. | Move the toggle up and release again. DRIVE 4 will appear on LCD. | |||
Toggle Switch |
| |||
5. | Move the toggle up and release one more time to select DRIVE 1. |
| ||
| Speed Control | |||
|
|
| ||
|
| Joystick | Knob | |
|
|
| ||
|
| Programmable Mono | Remote On/ | |
|
| Off Input | ||
|
| Port 1/2 or External | ||
|
|
| ||
|
| Mode Switch | To Controller | |
|
|
| ||
|
| FIGURE 5 MPJ+ Joystick Switches and Indicators | ||
Part No 1163181 | 43 | Invacare® FDX® | ||
