|
|
| 9 TROUBLESHOOTING |
|
|
|
|
SYMPTOM |
| PROBABLE CAUSE | SOLUTIONS |
|
|
|
|
JOYSTICK FAULT displays and the |
| The joystick or input device is | Replace joystick or input device. |
wheelchair does not drive. |
| sending a value outside of the |
|
|
| reverse, forward, left or right limits |
|
|
| (Error codes E01, E02, E03 or E04). |
|
|
|
|
|
NEUTRAL TESTING displays. |
| The joystick neutral test has failed | Release the joystick and try to get the joystick back into the |
|
| (Error code E18). | |
|
|
| |
BAD JOYSTICK CAL VALUES displays and | The joystick calibration values are | Recalibrate the joystick (joystick throw procedure). | |
the wheelchair does not drive. |
| outside of the expected range |
|
|
| (Error code E19). |
|
|
|
|
|
CTRL NOT CONNECTED |
| The MPJ or Display module is not | Check the connections between the joystick or display and |
|
| communicating with the control | the controller. Turn the power off and then back on. Replace |
|
| module (Error code E200). | the controller if necessary. |
|
|
|
|
CTRL COM FAULT displays and the |
| The controller has determined a | Turn the wheelchair off and back on. |
wheelchair drives slowly. |
| fault during a previous |
|
|
| process (Error code E41). |
|
|
|
| |
MISSING CONFIGURATION displays at | One or more devices have been | Reconnect the device. | |
power up. |
| removed or disconnected from the |
|
|
| wheelchair. |
|
|
|
|
|
|
| The Proportional or Digital | This is normal behavior. |
ATTENDANT ACTIVE and | displays. | Attendant control is active and can |
|
be used to drive the chair. |
| ||
|
|
| |
|
|
| |
Batteries draw excessive current when | Battery failure. | Have batteries checked for shorted cell. Replace if necessary. | |
charging. |
|
|
|
|
|
| Contact Dealer/Invacare for service. |
|
| Electrical malfunction. |
|
|
|
|
|
Part No 1163181 | 95 | Invacare® FDX® |
