2 SAFETY

Footplates and Front Rigging

￿ WARNING

If the wheelchair dips forward and the footplates touch the ground while the wheelchair is in motion, please contact your dealer for an inspection and avoid use of the wheelchair if possible. Otherwise the user could be injured.

ALWAYS maintain a minimum of 3-inches between bottom of the front riggings and the floor/ground while the wheelchair is in motion to ensure proper ground clearance. If necessary, adjust the front rigging height or tilt seat to achieve proper ground clearance.

DO NOT use the footplates as a platform. When getting in or out of the wheelchair, make sure that the footplates are in the upward position or swing footrests towards the outside of the wheelchair.

Reaching, Leaning and Bending - Forward

Engage motor locks and turn power off before reaching, leaning or

.

￿

WARNING

DO NOT attempt to reach objects if you have to move forward in the seat or pick them up from the floor by reaching down between your knees.

Proper positioning is essential for your safety. Improper positioning while leaning or bending could cause the wheelchair to tip forward onto anti-tippers.

For this procedure, refer to FIGURE 2.

bending only as far as your arm will extend without changing your sitting position.

FIGURE 2 Reaching, Leaning and Bending - Forward

Part No 1163181

21

Invacare® FDX®

Page 21
Image 21
Invacare FDX-CG, FDX-MCG user manual Footplates and Front Rigging, Reaching, Leaning and Bending Forward