Apple 640 manual Installing Windows for Workgroups, Installing Spry’s Air Series TCP/IP software

Installing Windows for Workgroups

1

2

3

To support networking with your DOS-compatibility hardware, you need to install software that supports ODI (Open Data-Link Interface) drivers. Follow these steps:

Install Windows for Workgroups 3.1.1, electing to not install the networking software. Follow the instructions in “Installing NetWare Client Software,” earlier in this appendix.

Follow the instructions in “Installing NetManage’s Chameleon TCP/IP Software,” earlier in this appendix.

Installing Spry’s Air Series TCP/IP software

IMPORTANT You must not have MacTCP installed when you run DOS TCP/IP software; the two will conflict with one another.

You can use the IPX and TCP protocols at the same time in the PC environment or in the Mac OS, or you can use one protocol in the PC environment and the other protocol in the Mac OS. However, you cannot use the same protocol in both environments at the same time.

If you want to use the IPX protocol in the PC environment and you have previously installed MacIPX in the Mac OS, remove MacIPX from the Control Panels folder or select AppleTalk as your network interface in the MacIPX control panel.

If you want to use the TCP protocol in the PC environment and you have previously installed MacTCP in the Mac OS, remove MacTCP from the Control Panels folder or select an interface other than Ethernet in the MacTCP control panel.

You must have Windows installed before you can install Spry’s Air Series TCP/IP software. If you need to reinstall Windows, see “Reinstalling PC Software” in the section “Reinstalling the DOS-Compatibility Software” in Chapter 8.

Installing Network Management Software 163