In addition, you need to know the Ethernet frame type in use on your
network segment. You must choose the appropriate frame type in Step 11
below. If you are not certain which one to select, ask your network
administrator before you begin the installation.
1Insert the
NetWare Client for DOS WSDOS_1
disk into the disk drive.
2At the DOS prompt, type the following:
A: <return>
INSTALL
3 The NetWare Client Install screen appears.
Follow the instructions on screen, pressing Return for each selection.
4 Define the directory for NetWare.
The default is C:\NWCLIENT. Press Return once to confirm the entry and
press it again to execute this step.
5Edit the CONFIG.SYS file.
Change your LASTDRIVE statement so that it reads LASTDRIVE=Z.
6Add the following line to your AUTOEXEC.BAT file:
CALL C:\NWCLIENT\STARTNET.BAT
Press Y-Return.
7 Decide whether you wish to load the Windows support in the directory where you have
loaded Windows.
Press Y or N. If yes, press Return once to confirm the Windows subdirectory
entry and again to execute this step.
8Select the driver for the network board. Press Return.
9A message asks you to insert another disk. Follow the instructions on the screen.
10 In the dialog box, select Power Macintosh 6100 Ethernet Adapter and press Return.
11 In the dialog box for selecting a frame type, press Return.
154 Appendix D