Monogram.™
Installation at End of Run
Refrigerator or Freezer
1/2" Thick
Side Panels
Finished Dim. 36"
Refrigerator and Freezer installed
| 1/2" Thick |
| Side Panels |
Finished Dim. | 72" |
| 73" | |
|
Refrigerator
Cabinet
Refrigerator door
Cabinet
Note: 1/2" thick side panels shown. Side panels can be any thickness. Add side panel thickness to outside trim width, (36” or 72" for two models) to calculate the
Frameless Cabinets
Side panels, 1/2" minimum thickness are required when using frameless cabinets. The side panel acts as a spacer between the cabinet and the case trim and prevents interference with cabinet door swing. The leading (front) edge must be finished to match surrounding cabinetry.
1/2" To 3/4" Side Panels. Leading
Edge Flush With Cabinet
Refrigerator |
Cabinet |
Refrigerator door |
Accessory Panel Kits
These refrigerators and freezers require field installed door and grille panels.The factory installed trim will accept accessory panel kits. White or black Lexan® and stainless steel kits are available. Panels are cut to size and ready to install. These panel kits must be ordered separately.
ZWBR36, Black Lexan® Panels
ZWWR36, White Lexan® Panels
ZWSR36, Stainless Steel Panels
A wide range of custom appearance options can be created with optional trim kits.
Accessory Panel Kits Advanced Planning Exterior Appearance Options
These refrigerators and freezers are designed to be customized with decorator door and grille panels. Field installed custom door and grille panels are required for these models.
Factory installed trim will accommodate 1/4" thick custom panels, Lexan® or stainless steel panel kits.
Door and grille panel sizes vary to accommodate the kit being used. Sizes are provided in this booklet.
Caution: Maximum door panel weight is 50 pounds.
Side panels must be used whenever the sides of the refrigerator will be exposed. Side panel sizes vary depending on the installation.
3/4" thick custom panels-Without trim kits
A raised panel design, screwed or glued to a 1/4" thick backing can be used.
You should:
1.Select the appearance option.
2.Order the trim kit for that option.
3.Order the custom door and grille panels from the cabinet manufacturer. The exact dimension for each trim kit application is provided in this booklet. Find and pull out the page for your application and fax or send it to the cabinet manufacturer. The cabinet manufacturer must have this information to construct the panels accurately.
4.Determine the final installation situation and order matching
side panels.
For answers to your Monogram,®
GE Profile Performance Series,™
GE Profile™ or GE appliance questions, call
GE Answer Center® service, 800.626.2000.
Specification Created 8/00
Listed by
Underwriters
RLaboratories