Pioneer D514, VSX-D414 manual 02 5 minute guide, Using the Quick Setup

025 minute guide

4Plug in the receiver and switch it on, followed by your DVD player, your subwoofer and the TV.

Make sure you’ve set the video input on your TV to this receiver. Check the manual that came with the TV if you don’t know how to do this.

Also make sure that DVD/LD is showing in the receiver’s display, indicating that the DVD input is selected. If it isn’t, press DVD/LD to set the receiver to the DVD input.

5Press QUICK SETUP on the front panel to specify your speaker setup and your

Using the Quick Setup

You can use the Quick Setup to get your system up and running with just a few button presses. The receiver automatically makes the necessary settings after you have selected your speaker setup and room size. If you want to make more specific settings, refer to Choosing your receiver setup on pages 31 to 35. Use the front panel controls for the steps below.

AUDIO/VIDEO MULTI-CHANNEL RECEIVER VSX-D514

room size.

Use the MULTI JOG dial to select and ENTER to confirm your selection. See Using the Quick Setup below if you’re unsure about the settings.

6Play a DVD, and adjust the volume to your liking.

There are several other sound options you can select. See pages 26 to 28 for more on this. See also Choosing your receiver setup on pages 31 to 37 for more setup options.

MULTI JOG

ENTER

MASTER VOLUME

R	VSB	TONE QUICK SETUP
CE	MODE		DOWN	UP

MULTI JOG

Depending on your DVD player or source discs, you may only get digital 2 channel stereo and analog sound. In this case, the listening mode must be set to STANDARD (it should already be set—see page 26 if you need to do this) if you want multi-channel surround sound.

1Press STANDBY/ON to turn the power on.

2Press QUICK SETUP.

The display prompts you to select your speaker setup.

3Use the MULTI JOG dial to choose your speaker setup.

Cycle between the following choices:

	5.1ch	5.0ch	4.1ch
2.0ch				4.0ch
	2.1ch	3.0ch	3.1ch

10

En