INSTALLATION
OPTIONAL
SIDE SHELF
Contents:
Qty.
1Side Shelf
2Side Shelf Bracket
4Screws (1/4" x 1/2")
1)Screw the 2 side shelf brackets to the underside of the stove hob. Diagram 1.
LOG INSTALLATION
WARNING: Dangerous operating con- ditions may occur if these logs are not positioned in their approved locations. Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot and burner operation.
There are 5 logs in the set: 1 Rear Log, 1 Front Log, 1 Middle Log and 2 Top Logs.
The logs are fragile, handle with care
1)Remove the Cast Iron Front Panel (see page 26).
2)Remove the Front Glass Panel and frame (see page 26.)
3)Place the rear log on the 2 rear pins in the log support tray.
5)Place the middle log on the 2 middle log pins.
6)Place the 2 top logs in position on the middle and rear logs as shown below. Place the right log as close to the knot on the rear log as possible.
7)Replace the Front Glass Panel and frame and tighten the fixing bolts.
8)Replace the Cast Iron Front Panel.
Diagram 1
2)Place the side shelf onto the 2 brackets and secure with 2 screws. Diagram 2.
Diagram 2
3)Align the side shelf so that it is centered on the hob making sure not to damage the enamel finish. Once aligned, tighten all screws. Diagram 3.
Diagram 3
Note: Do not force logs down.
4)Place the front log on the log support tray. Ensure that it is pulled all the way to the front and towards the right side of the firebox.
OPTIONAL WALL
THERMOSTAT
A wall thermostat may be installed if desired. Connect the wires as per the wiring diagrams. Note that the wires are connected to the "TH" on the gas valve. Use table on page 27 to determine the maximum wire length:
Note: Preferable if the thermostat is in- stalled on an interior wall.
Waterford offers an optional programmable thermostat but any
CAUTION
Do not connect the millivolt wall
thermostat wires to the 120V wires.
Waterford TARA T25 Direct Vent Freestanding Gas Stove | 27 |
