![HIGH ELEVATION](/images/new-backgrounds/53989/5398945x1.webp)
INSTALLATION
Diagram 7
4)To determine the length of flex required, measure from 3" (76mm) above the top of the Flashing down to the level of the open- ing. Add to this measurement the distance from the center of the chimney to out through the wall. Cut a piece of 4" flex to this length (the flex should already be extended to its nominal length).
5)Connect the 4" flex liner to the Top Adaptor (Part # 985K) using 3 sheet metal screws. Diagram 2.
6)Feed the 4" flex liner through the Flashing into the chimney. Continue to feed the liner out through the opening in the masonry wall.
7)Secure the Top Adaptor to the Flashing. Use 3 sheet metal screws through the side of the adaptor into the flange on the Flashing (diagram 8). Twist lock the Termination Cap (Part # 980 or 991) on to the Top Adaptor.
Diagram 8
8)Attach the flex to the Retro Connector. Use 3 sheet metal screws to attach the flex liner to the Connector. Diagram 9. Mount the Retro Connector to the masonry wall using masonry bolts.
Diagram 9
9)Slide the Wall Thimble Cover (Part # 940) over the Retro Connector and secure with masonry bolts. Diagram 10. If you have a framed wall in front of the masonry, use wood screws to mount the Wall Thimble Cover to the framed wall, over the Retro Connector and the 10" (254mm) square framed opening. Diagram 11. If needed, add a section of direct vent pipe to the Retro Connector in order to extend through the opening in the Wall Thimble Cover.
Diagram 10
Diagram 11
10)The connection between the appliance and the Retro Connector may be completed with a section of black direct vent pipe, together with an adjustable length pipe section.
HIGH ELEVATION
This unit is approved in Canada for altitude to4500 ft.
In U.S.A., for installations above 2000 ft. refer to current ANSI Z223.1
System Data - TARA T25
| For 0 to 4500 feet altitude |
|
| ||
| Burner Inlet Orifice Sizes: |
|
| ||
| Natural Gas | Propane |
| ||
| Burner | #41 |
| #53 |
|
|
|
|
|
| |
| Max. Input Rating |
|
|
| |
| - Natural Gas |
| 25,000 Btu/h |
| |
| - Propane |
| 25,000 Btu/h |
| |
| Min. Input Rating |
|
|
| |
| - Natural Gas |
| 15,000 Btu/h |
| |
| - Propane |
| 13,000 Btu/h |
| |
|
|
|
|
| |
| Output Capacity |
|
|
| |
| Natural Gas |
| 18,875 Btu/h |
| |
| Propane |
| 19,250 Btu/h |
| |
|
|
|
|
| |
| Supply Pressure |
|
|
| |
| Natural Gas |
| min. | 5.0" w.c. |
|
| Propane |
| min. | 12.0" w.c. |
|
|
|
|
|
| |
| Manifold Pressure |
|
|
| |
| Natural Gas |
| 3.8" | +/- 0.2" w.c. |
|
| Propane |
| 11" | +/- 0.2" w.c. |
|
Waterford TARA T25 Direct Vent Freestanding Gas Stove | 23 |