Pioneer VSX-1017AV-K, VSX-1017AV-S manual Operating Environment

Page 3
K058_A_En
D3-4-2-1-7c_A_En
K041_En
D3-4-2-2-1a_A_En

If the AC plug of this unit does not match the AC outlet you want to use, the plug must be removed and appropriate one fitted. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. If connected to an AC outlet, the cut-off plug can cause severe electrical shock. Make sure it is properly disposed of after removal.

The equipment should be disconnected by removing the mains plug from the wall socket when left unused for a long period of time (for example, when on vacation).

CAUTION

The STANDBY/ON switch on this unit will not completely shut off all power from the AC outlet. Since the power cord serves as the main disconnect device for the unit, you will need to unplug it from the AC outlet to shut down all power. Therefore, make sure the unit has been installed so that the power cord can be easily unplugged from the AC outlet in case of an accident. To avoid fire hazard, the power cord should also be unplugged from the AC outlet when left unused for a long period of time (for example, when on vacation).

D3-4-2-2-2a_A_En

Operating Environment

Operating environment temperature and humidity:

+5 ºC to +35 ºC (+41 ºF to +95 ºF); less than 85 %RH (cooling vents not blocked)

Do not install this unit in a poorly ventilated area, or in locations exposed to high humidity or direct sunlight (or strong artificial light)

This product is for general household purposes. Any failure due to use for other than household purposes (such as long-term use for business purposes in a restaurant or use in a car or ship) and which requires repair will be charged for even during the warranty period.

If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling.

Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one).

For countries not mentioned above, please contact your local authorities for the correct method of disposal.

By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health.

Page 2 Page 4
Image 3
Page 2 Page 4
Contents VSX-1017AV-SVSX-1017AV-K Risk of Electric Shock Do not Open Important the Moulded PlugOperating Environment Contents Other connections System Setup menuOther Settings Using other functionsFeatures Before you startBefore you start Chapter Installing the receiver Before you start Checking what’s in the boxLoading the batteries Introduction to home theater Automatically setting up for surround sound Auto McaccMinute guide 02 5 minute guide ChapterMinute guide Make sure ‘TYPE1’ is selected then press ENTER.3Follow the instructions on-screen Playing a source Better sound using Phase ControlProblems when using the Auto Mcacc Setup 02 5 minute guideConnecting your equipment Connecting your equipment ChapterRear panel Connecting your equipment When making cable connectionsAbout the video converter 342 Connecting your equipment Connecting your TV and DVD playerConnecting a satellite/cable receiver or other set-top box Connect using a standard video cable or an S-video cableConnecting a DVD/HDD recorder, VCR and other video sources Using the component video jacksDVR, VCR, etc Connecting using Hdmi Use a three-way component video cableOn an HDMI-compatible monitor.1 Connecting digital audio sources About HdmiCD-R, MD, DAT, etc This unit has an on-board Windows MediaTM Audio Connecting analog audio sourcesConnect using a stereo RCA/phono jack audio cable About the WMA9 Pro decoderConnecting the speakers Connecting your equipment Installing your speaker systemPlacing the speakers Bare wire connectionsTHX speaker system setup Connecting antennasConnecting external antennas Plug the power cord into a power outletPlugging in the receiver Controls and displays Controls and displays ChapterFront panel Controls and displays Operating range of remote control unitControls and displays Display Select Controls and displays Remote controlRECEIVER Input SelectReceiver Multi OPEShift SOURCEAuto playback Listening to your systemListening to your system Chapter Listening in surround soundListening to your system Using the Home THX modesUsing the Advanced surround effects THX Games ModeListening in stereo Using Front Stage Surround AdvanceSetting the effect options Setting What it does OptionsListening with Acoustic Calibration EQ Listening to your system Using Stream DirectChoosing the input signal Using surround back channel processingPro Logic Using the Virtual Surround Back modePress Tone to select the frequency you want to adjust Listening to your system Using Midnight and LoudnessUsing the Sound Retriever Using the tone controlsBasic playback controls Using the USB interfaceUSB playback USB playback ChapterCompressed audio compatibility USB playbackListening to the radio Using the tunerUsing the tuner Chapter Saving station presetsAn introduction to RDS Using the tunerNaming station presets Listening to station presetsUsing EON Displaying RDS informationPress Disp for RDS information Surround back speaker setting System Setup menuSystem Setup menu Chapter Making receiver settings from the System Setup menuFine Channel Level System Setup menu Manual Mcacc setupSelect ‘Manual MCACC’ from the System Setup menu Select ‘Fine Ch Level’ from the Manual Mcacc setup menuFine Speaker Distance System Setup menuSelect ‘Fine SP Distance’ from the Manual Mcacc setup menu Volume increases to the reference levelCopying your Acoustic Calibration EQ settings Setting the Acoustic Calibration EQ automaticallySetting the Acoustic Calibration EQ manually Checking your Acoustic Calibration EQ settingsFront Align System Setup menu Manual speaker setup Speaker SettingSelect ‘Manual SP Setup’ then press Enter Channel Level Crossover NetworkTHX Audio Setting THX Speaker SetupSpeaker Distance Other connections Chapter Connecting an iPodConnecting your iPod to the receiver Other connectionsSelecting the multichannel analog inputs Connecting the multichannel analog inputsWatching photos and video content Other connectionsPress Multi CH in front panel Speaker B setupSwitching the speaker system Bi-amping your front speakersConnecting additional amplifiers Bi-wiring your speakersLarge Satellite receiver, etc DVD playerPioneer plasma DisplayDVD Assigning the digital inputs Other SettingsOther Settings Chapter Input Assign menuAssigning the Hdmi inputs Other SettingsOther Setup menu Dynamic Range Control SetupVideo Converter Setup Dual Mono SetupLFE Attenuator Setup SR+ Setup for Pioneer plasma displaysUsing the sleep timer Using other functionsUsing other functions Chapter Reducing the level of an analog signalPress System Setup to confirm Using other functions Dimming the displaySwitching the speaker impedance Resetting the systemControlling the rest of your system Programming a multi-operation or a shutdown sequence Select the button for the command you want to inputControlling the rest of your system Multi Operation and System OffButtons Function Components Using multi operationsUsing System off Controls for TVsCD/MD/CD-R Decide which component you want to use the remote sensor Additional information Chapter TroubleshootingPower Additional informationOther audio problems SymptomRemedyAdditional information Video SettingsDisplay Remote controlSymptom Cause Action USB interfaceIPod messages Dolby Additional information Surround sound formatsWindows MediaTM Audio 9 Professional About THXAuto Surround Listening modes with different input signal formatsStereo 2 channel signal formats StandardInput signal format Standard Multichannel signal formatsCleaning the unit Additional information SpecificationsPioneer Corporation
Top Page Image Contents