Pioneer SX-A9MK2-K manual Other connections Connecting an IR receiver, Component, Pioneer

Other connections

Connecting an IR receiver

If you keep your stereo components in a closed cabinet or shelving unit, you can use an optional IR receiver (such as a Niles or Xantech unit) to control your system instead of the remote sensor on the front panel of this receiver.1

1Connect the IR receiver sensor to the IR IN jack on the rear of this receiver.

Closet or shelving unit

	Non-Pioneer
IR	component
IN
	Pioneer
CONTROL	component
IN OUT
	CONTROL

Operating other Pioneer components with this unit’s sensor

Many Pioneer components have SR CONTROL jacks which can be used to link components together so that you can use just the remote sensor of one component. When you use a remote control, the control signal is passed along the chain to the appropriate component.

•Note that if you use this feature, make sure that you also have at least one set of analog audio jacks connected to another component for grounding purposes.

1Connect the CONTROL OUT of this receiver to the CONTROL IN jack of another Pioneer component.

Use a cable with a mono mini-plug on each end for the connection.

06

English

USB	XM		IR	OUT
AUDIO IN IN		IN	OUT
				SIGNAL
			R	GND
				R
			L	L
				MM/MC
AUX1	AUX2	CD		PHONO

This receiver

IR receiver

	This receiver
Pioneer
component	IR	CONTROL
remote		OUT
	OUT
control
		SIGNAL
	L	GND

Pioneer component

CONTROL

IN OUT

2Connect the IR IN jack of another component to the IR OUT jack on the rear of this receiver to link it to the IR receiver. Please see the manual supplied with your IR receiver for the type of cable necessary for the connection.

•If you want to link a Pioneer component to the IR receiver, see Operating other Pioneer components with this unit’s sensor below to connect to the CONTROL jacks instead of the IR OUT jack.

2If the Pioneer component also has a CONTROL OUT jack, you can continue the chain in the same way for as many components as you have.

Note

1• Remote operation may not be possible if direct light from a strong fluorescent lamp is shining on the IR receiver remote sensor window.

•Note that other manufacturers may not use the IR terminology. Refer to the manual that came with your component to check for IR compatibility.

•If using two remote controls (at the same time), the IR receiver’s remote sensor takes priority over the remote sensor on the front panel.

23

En