Pioneer VSX-LX70 manual Controls for TVs, Using multi operations, Using System off

Controlling the rest of your system 12

5 Use	to select a command in the sequence then
press ENTER.

If this is the first command in the sequence, select 1ST CODE. Otherwise, simply choose the next command in the sequence. PRES KEY flashes after you press ENTER.

6If necessary, press the input source button for the component whose command you want to input.

This is only necessary if the command is for a new component (input source).

7Select the button for the command you want to input.

The following remote control commands can be selected:

RECEIVER INPUT	SYSTEM OFF
	SOURCE
SELECT

Using multi operations

You can start multi operations with the receiver switched on, or in standby.

PHOTO		T.DISP	STEREO/
STATUS	SIGNAL SEL SBch		F.S.SURR
MULTI OPE	THX	STANDARD	ADV. SURR

SHIFT PHASE MCACC S.DIRECT

RECEIVER

1 Press MULTI OPE.

MULTI OP flashes in the display.

2Press an input source button that has been set up with a multi operation.

The receiver switches on (if it was in standby) and the programmed multi operation is performed automatically.

Using System off

CD	CD-R		HDMI
DVD	TV	BD	TVCTRL
DVR2	HOME MEDIA		ZONE2/3
	GALLERY
DVR1	iPod	TUNER	RECEIVER
	SLEEP	DIMMER	ANALOG
			ATT
	SR+	GENRE				TV CONTROL
				TV VOL	INPUT		TV CH	VOL
					SELECT
D.ACCESS			CLASS
	CLEAR		DISC
	+10	CH	ENTER
		LEVEL		TV/DTV		REC	INFO
A PARAMETER			V PARAMETER
								MUTE
TOP MENU			MENU T.EDIT
	TUNE			MPX			REC STOP	JUKEBOX
BAND	ST	ST
SETUP	ENTER		RETURN	AUDIO	SUBTITLE		HDD	DVD
	TUNE					DISP	CH	CH
				PHOTO		T.DISP
PROGRAM								STEREO/
				STATUS	SIGNAL SEL		SBch
	TV CONTROL							F.S.SURR

•You don’t need to program the receiver to switch on or off. This is done automatically.

With Pioneer components, you don’t need to:

•program the power to switch off in a shutdown sequence (except DVD recorders);

•program the power to switch on if it’s the source component selected in step 3;

•program a Pioneer TV or monitor to switch on if the input function (selected in step 2) has video input terminals;

These take priority in multi operations (not shutdown).

8Repeat steps 5–7 to program a sequence of up to five commands.

		INPUT	SYSTEM OFF	PHOTO T.DISP			STEREO/
	RECEIVER		SOURCE
				STATUS	SIGNAL SEL	SBch
		SELECT					F.S.SURR
				MULTI OPE	THX	STANDARD ADV. SURR
				SHIFT	PHASE	MCACC	S.DIRECT
	CD	CD-R	HDMI		RECEIVER
	DVD	TV BD	TVCTRL
		HOME MEDIA
1	Press MULTI OPE.
MULTI OP flashes in the display.
2	Press SOURCE .

The command sequence you programmed will run, then

all Pioneer components will switch off1, followed by this receiver.

Controls for TVs

This remote control can control components after entering the proper codes or teaching the receiver the commands (see Setting the remote to control other components on page 74 for more on this). Use the input source buttons to select the component.

9 When you’re finished, use	to select EDITEXIT
from the menu and press ENTER.

You will return to the remote control SETUP menu. Select

*EXIT * again to exit.

Note

1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.

77

En