Pioneer VSX-LX70 Listening in stereo, Using Front Stage Surround Advance, Using Stream Direct

Listening to your system 05

Tip

•When an Advanced Surround listening mode is selected, the effect level can be adjusted using the EFFECT parameter in Setting the Audio options on page 68.

Listening in stereo

When you select STEREO, you will hear the source through just the front left and right speakers (and possibly your subwoofer depending on your speaker settings). Dolby Digital, DTS and WMA9 Pro multichannel sources are downmixed to stereo.

PHOTO		T.DISP	STEREO/
STATUS	SIGNAL SEL SBch		F.S.SURR
MULTI OPE	THX	STANDARD	ADV. SURR

SHIFT PHASE MCACC S.DIRECT

RECEIVER

•While listening to a source, press STEREO/F.S.SURR for stereo playback.

Press repeatedly to switch between:

•STEREO – The audio is heard with your surround settings and you can still use the Midnight, Loudness, and Tone functions.

•F.S.SURR FOCUS – See Using Front Stage Surround Advance below for more on this.

•F.S.SURR WIDE – See Using Front Stage Surround Advance below for more on this.

Using Front Stage Surround Advance

The Front Stage Surround Advance function allows you to create natural surround sound effects using just the front speakers and the subwoofer.

PHOTO		T.DISP	STEREO/
STATUS	SIGNAL SEL SBch		F.S.SURR
MULTI OPE	THX	STANDARD	ADV. SURR

SHIFT PHASE MCACC S.DIRECT

•F.S.SURR WIDE – Use to provide a surround sound effect to a wider area than FOCUS mode.1

FOCUS position (Recommend)		WIDE position
Front left	Front right	Front left	Front right
speaker	speaker	speaker	speaker

Using Stream Direct

Use the Stream Direct modes when you want to hear the truest possible reproduction of a source. All unnecessary signal processing is bypassed, and you’re left with the pure analog or digital sound source (see Stream direct with different input signal formats on page 92).

PHOTO		T.DISP		STEREO/
STATUS	SIGNAL SEL		SBch	F.S.SURR
MULTI OPE		THX	STANDARD	ADV. SURR

SHIFT PHASE MCACC S.DIRECT

RECEIVER

1 While listening to a source, press S.DIRECT

(AUTO SURR/STREAM DIRECT) to select the mode you want.

Check the digital format indicators in the front panel display to see how the source is being processed.

•AUTO SURROUND – See Auto playback on page 29.

•DIRECT – Sources are heard according to the settings made in the Surround Setup (speaker setting, channel level, speaker distance, acoustic calibration EQ, and X-curve), as well as with dual mono, the input attenuator, and any sound delay and hi-bit/hi-sampling settings. You will hear sources according to the number of channels in the signal.

•PURE DIRECT – Analog and PCM sources are heard without any digital processing.2 No sound is output from the Speaker B in this mode.

RECEIVER

•While listening to a source, press STEREO/F.S.SURR to select Front Stage Surround Advance modes.

•STEREO – See Listening in stereo above for more on this.

•F.S.SURR FOCUS – Use to provide a rich surround sound effect directed to the center of where the front left and right speakers sound projection area converges.

Note

1When using F.S.SURR WIDE, a better effect can be obtained if Auto MCACC Setup is performed. For more on this, refer to Automatically setting up for surround sound (MCACC & Full Band Phase Control) on page 8.

2There are cases where a brief noise is heard before playback of sources other than PCM. Please select AUTO SURROUND or DIRECT if this is a problem.

31

En