Pioneer VSX-01TXH manual Using other functions Resetting the system, Default system settings

Using other functions 11

Resetting the system

Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.

1Switch the receiver into standby.

2While holding down the front panel STEREO/A.L.C button, press and hold  STANDBY/ON for about two seconds.

The display shows RESET?.

3Press the front panel AUTO SURR/STREAM DIRECT button.

The display shows OK.

4Press HOME THX to confirm.

OK appears in the display to indicate that the receiver has been reset to the factory default settings.

•Note that all settings will be saved, even if the receiver is unplugged.

Default system settings

Setting		Default
HDMI Audio		Amp
HDMI Control		ON
Digital Video Conversion		ON
Speakers		A
Surround Back System		Normal
Speaker System	Front	SMALL
	Center	SMALL
	Surr	SMALL
	SB	SMALLx2
	SW	YES
Crossover		80 Hz
X-Curve		OFF
THX Audio Setting		0–1 ft.
Inputs

See Input function default and possible settings on page 70.

MULTI-ZONE

Zone 2 Volume Type	Variable
Zone 2 Volume	–60 dB
SR+
SR+ Control On/Off	OFF
SR+ Volume Control On/Off	OFF
Monitor Out	OFF
DSP
Surround back channel Processing	ON
Phase Control	ON
Sound Retriever	OFF

Setting		Default
Sound Delay		0.0 frame
Dual Mono		CH1
DRC		OFF
SACD Gain		0 dB
LFE Attenuate		0 dB
Auto delay		OFF
Digital Safety		OFF
Effect Level	Extended Stereo	90
	Other modes	50
2 PL II Music	Center Width	3
Options
	Dimension	0
	Panorama	OFF
Neo:6 Options	Center Image	3 (Neo:6 Music)
		10 (Neo:6
		Cinema)
All Inputs	Listening Mode	AUTO
	(2 ch)	SURROUND
	Listening Mode	AUTO
	(x ch)	SURROUND
	Listening Mode	STEREO
	(HP)

See also Setting the Audio options on page 73 for other default DSP settings.

MCACC

MCACC Position Memory		M1: MEMORY 1
Channel Level (M1–M6)		0.0 dB
Speaker Distance (M1–M6)		10’00’’
		(10 ft. 00 in.)
Standing Wave	ATT	0.0 dB
(M1–M6)
	SWch Wide Trim	0.0 dB
EQ Data (M1–M6)	All channels/bands	0.0 dB
	EQ Wide Trim	0.0 dB

77

En