TK-260G/270G
GENERAL / SYSTEM SET-UP
INTRODUCTION
SCOPE OF THIS MANUAL
This manual is intended for use by experienced technicians familiar with similar types of commercial grade communications equipment. It contains all required service information for the equipment and is current as of the publication date. Changes which may occur after publication are covered by either Service Bulletins or Manual Revisions. These are issued as required.
●SHUT OFF and DO NOT operate this equipment near electrical blasting caps or in an explosive atmosphere.
●This equipment should be serviced by a qualified technician only.
SERVICE
This radio is designed for easy servicing. Refer to the schematic diagrams, printed circuit board views, and alignment procedures contained within.
ORDERING REPLACEMENT PARTS
When ordering replacement parts or equipment information, the full part identification number should be included. This applies to all parts, components, kits, or chassis. If the part number is not known, include the chassis or kit number of which it is a part, and a sufficient description of the required component for proper identification.
NOTE
WE CANNOT guarantee oscillator stability when using channel element manufactured by other than KENWOOD or its authorized agents.
PERSONNEL SAFETY
The following precautions are recommended for personnel safety:
●DO NOT transmit until all RF connectors are verified secure and any open connectors are properly terminated.
Unit |
|
|
|
|
|
| |||
Model & | Frequency range | Remarks | Helical Antenna | Charger | Battery | 16 Key | |||
|
| ||||||||
destination |
|
|
|
|
|
| |||
K | _ | – |
|
| OP |
|
| – | |
_ | – |
| IF1 : 49.95MHz | _ |
|
| – | ||
M | 150~174MHz | OP | OP | ||||||
K | _ | _ | LOC : 50.4MHz | OP | _ | ||||
|
|
| |||||||
_ | _ |
|
| _ |
|
| _ | ||
M |
|
|
|
|
SYSTEM SET-UP
Merchandise received
License and frequency allocated by FCC
|
|
|
|
|
|
|
|
|
|
|
| Frequency range (MHz) | RF power | Type | |
Choose the type of transceiver |
|
| |||||
|
|
|
|
|
| ||
| TX/RX 150~174 | 5.0W | |||||
|
|
|
| ||||
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Transceiver programming
A personal computer (IBM PC or compatible), programming interface
(The frequency, TX power HI/LOW, and signalling data are programmed for the transceiver.)
Are you using the speaker microphone?
NO
YES
(Option)
Delivery
2