Atlas Sound TSD-MIX31RL owner manual Dip Switch Function Identification Switch Position, Mounting

Page 5

Owner’s Manual

TSD-MIX31RL

3x1 Mic/Line Mixer

Dip Switch Function Identification

Switch Position

DIP SW # 1,2 - 24VDC Phantom Power applies power for condenser mic operation to corresponding input terminal. Down position is On.

DIP SW # 3 - Input Mic or Line Select for input gain selection for Input 1. Up position is Line, down position is Microphone.

DIP SW # 4 - Low Cut Filter engages at 125Hz with a roll off rate of 12dB per octave. This filter operates either in the Line or Mic mode and is available on Input 1. Ideal for vocal microphones to reduce low frequency energy and to increase intelligibility. Down position is On.

DIP SW # 5 - Input Mic or Line Select for input gain selection for Input 2. Up position is Line, down position is Microphone.

DIP SW # 6 - Low Cut Filter engages at 125Hz with a roll off rate of 12dB per octave. This filter operates either in the Line or Mic mode and is available on Input 2. Ideal for vocal microphones to reduce low frequency energy and to increase intelligibility. Down position is On.

DIP SW # 7 - Input 3 Mute Receive will mute audio present at Input 3 when audio is present at

Input 1. Down position is On.

DIP SW # 8 - Remote Level sets whether the remote volume control adjusts all inputs mixed or

Input 3 only. Up position is all inputs, down position is Input 3 only.

Knob and Security Cover

All front panel level controls feature a removable knob that can be replaced with an included security cover. Follow these steps to prevent potentiometer damage or unwanted changes.

1.Knob Installation - Turn the potentiometer shaft fully counter-clockwise. Align the knob indicator to the lowest setting on the panel and the potentiometer shaft slot. Carefully press the knob onto the potentiometer shaft. Do not force or damage may occur to the potentiometer.

2.Security Cover Installation – Remove the knob from the panel and insert the cover. Do not force or damage may occur to the potentiometer. Small pliers may be required to remove the knobs.

Mounting

There are three ways to securely mount this TSD:

1.Velcro™ - Each unit includes industrial grade Velcro™ with adhesive to adhere to any flat surface.

2.Brackets - Each unit includes two mounting brackets to secure to a cabinet or wall.

3.Rack Mount Panel - The optional TSD-RMK panel supports up to four TSDs in a 1RU space.

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800.876.3333 • Fax: 800.765.3435

– 5 –

AtlasSound.com

Specifications are subject to change without notice.

Image 5
Contents TSD-MIX31 Installation FeaturesDescription Audio ApplicationsFront Panel Description Rear Panel Description Knob and Security Cover Dip Switch Function Identification Switch PositionMounting There are three ways to securely mount this TSDSpecifications Block DiagramInputs Maximum Input 40mV -27dBVPower Requirements IndicatorsAccessories Safety and CertificationsAtlas Sound Tech Support can be reached at Limited WarrantyService