EAW DX810 instruction manual TOP Section, Menu Bar

Page 15

TOP SECTION

Edit

The Top Section includes the Menu bar, the Active Logic Input and Output indicators, and Preset, On Line, and Panel Lock controls.

Menu Bar

The following menus are available in the Menu bar at the top of the screen:

File

Open (Ctrl+O)

Opens a previously saved session. The Select Workspace File dialog box opens and allows you to select a session to open. Select a file and click Open, or double-click on the file to open it.

When offline, this loads the new settings into the application only, allowing you to edit and save them without being connected to the DX810.

When online, this loads the new settings into the application and the connected DX810, overwriting the existing settings in the DX810.

Caution: Make sure all downstream power amplifiers and powered speakers from the DX810 are OFF before loading new settings from a file into the DX810.

Save As

Saves the current session. Use this to save the session when you have made a change to it or to create a new session file. The Save the Session As... dialog box opens and allows you to save the settings under the current session name, or enter a new file name. Enter the new name and click Save.

Note: The extension (.dx8) is automatically appended to the filename. Use up to 20 alphanumeric characters.

Quit (Ctrl+Q)

Closes the DX-810-PC application. The DX810 will continue to operate with the current settings.

Copy Crosspoint (Ctrl+C)

Copies the gain setting of the selected crosspoint to the clipboard. Click the (S) in the crosspoint box to select it, then select Copy Crosspoint.

Copy Mix Levels (Ctrl+M)

Copies the gain settings of all the inputs for the selected output to the clipboard. Click the associated letter button (A-J) in the Output Section to select an output.

Paste Crosspoint (Ctrl+P)

Pastes the gain setting from the clipboard to the selected crosspoint. Click the (S) in the crosspoint box to select it, then select Paste Crosspoint.

Paste Mix Levels (Ctrl+L)

Pastes the input gain settings from the clipboard to the selected output. Click the associated letter button (A-J) in the Output Section to select an output, then select Paste Mix Levels.

Advanced

DX810 Unit Info

This opens a dialog box that contains the following information about the DX810 that is currently connected:

DX810 – 15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents DX810 Safety Instructions Introduction DX810 Digital Mixer KEY FeaturesFront Panel Features Rear Panel FeaturesInputs IEC AC Socket BUS a and B TrimRecord Out DX10e Expansion PanelConnections AC Power Considerations Connecting the Logic I/OConnecting the Remote BUS Set the Levels Quick StartMake the Connections Start UpAccessing the Digital Signal Processors Using InputsUsing the BUS a and B Inputs Software UpdatesUsing the Remote Controls Using the Direct OutputsUsing Outputs a Through J Using the Record OutputLogic Outputs Logic InputsUpgrading the Software Password ProtectionInstalling the Software Administrator LevelConnecting a PC Upgrading the FirmwareOverview Menu Bar TOP SectionSet Lock Code Firmware UpgradeConfigure COM Ports Set TemperatureClose Window Esc Set Powerup PresetSet Global Faders Windows AboutIndicators/Presets/Control Button Section Assignments Force CtrlLogic Out Proc Logic OutGroups Input ProcCombine Rules Mute IndRemotes Function Affected I/OCrosspoint Group Three Room CombinationAssign Combinations Band Graphic EQ Band Parametric EQCompress Over About GatingOption Crosspoint Matrix SectionOutput Section Input SectionGroup Section Exclusive Enable Program SelectionDX810 Block Diagram SpecificationsInputs / Outputs DX810 SpecificationsDX810 Disclaimer Service InformationAppendix a Logic Input Functions Appendix C Selection Remote Predefined Functions Appendix D Level Remote Predefined Functions EAW Commercial a Loud Technologies Inc. Company
Top Page Image Contents