| Fuse & Lamp Replacement |
Caution: Always replace with the exact same type lamp and fuse, unless otherwise specified by an authorized American DJ® technician. Replace with anything other than the specified part can damage your unit and will void your manufactures warranty.
Warning: If after you have replaced the lamp or fuse and you continue to blow either one, STOP using the unit. Contact customer support for further instructions, you may have to return the unit for servicing. Continuing to use the unit may cause serious damage.
Fuse Replacement:
Disconnect the unit’s main power supply. Insert a standard flat head screw driver in to the fuse holder housing. Turn the screwdriver in
Lamp Replacement:
Caution! Never open the unit when in use. Always disconnect the main power and allow the fixture ample time to cool before attempting to replace the lamp. Lamp replacement has been made simple by incorporating a split dome that is retained by thumb screws. Again, please remember to always replace with the exact same type lamp.
1.Be sure to follow the proper procedures when handling halogen lamps. Never touch the new lamp with your bare fingers.
2.Remove the three thumb screw that secure the upper half of the dome to the lower.
3.Carefully pull up the upper half of the dome to expose the lamp.
4.Remove and replace the lamp.
5.Reassemble in reverse order.
| Warranty Registration |
The
©American DJ Supply® - www.americandj.com -
| Cleaning |
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning the internal and external lenses should be carried out periodically to optimize light output.
1.Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2.Clean the external optics with glass cleaner and a soft cloth every 20 days.
4.Clean the internal optics with glass cleaner and a soft cloth every
5.Always be sure to dry all parts completely before plugging the unit back in.
Cleaning frequency depends on the environment in which the fixture operates (I.e. smoke, fog residue, dust, dew). In heavy use we recom- mend cleaning on a monthly basis. Periodic cleaning will ensure longevity, and crisp beam output.
| Trouble Shooting |
Trouble Shooting:
Listed below are a few common problems and solutions you should try before contacting customer support.
Unit rotates but has no light output from the unit;
1.Be sure you have connected your unit into a matching wall outlet.
2.Remove the lamp cover and be sure the lamp is seated in its socket properly. Occasionally lamps become loose during shipping be sure the lamp is push in to its socket all the way.
3.Be sure the lamp is good.
Unit does not rotate and lamp does not turn on;
1.Be sure you have connected your unit into a matching wall outlet.
2.Be sure the external fuse has not blown. The fuse is located on the side panel of the unit.
3.Be sure the unit is properly seated in the power outlet and the outlet has power.
©American DJ Supply® - www.americandj.com -