Rear Panel

Q6 r	e	w	q		Q3	Q4
						PUSH
t y		u i	o	Q0 Q1	Q2	Q5
qPHONO 1, 2, 3, 4 /CD 1, 2, 3, 4 input terminals				yUSB A terminal

Q1BOOTH OUT (BALANCED) connectors

These TRS terminals are balanced line output terminals whose signal levels are adjusted using the BOOTH LEVEL control provided on the top panel.

Pin layout (TRS):

Tip: Hot, Ring: Cold, Sleeve: GND

Q2SEND/Q3RETURN terminals

•These 1/4” TS mono terminals allow external processing of the program signal.

•When connect monaural type effect processor, use Lch input and output.

SEND (output):

Connect this to the input terminal on the external effector.

RETURN (input):

Connect this to the output terminal on the external effector.

Q4MIC1 input terminal

A microphone is connected to this balanced combo jack with XLR connector or with 1/4-inch

Getting Started Connections Basic Operations Effector Function

These unbalanced stereo RCA terminals are used to connect devices such as a turntable (RIAA) with an MM (moving magnet) type of cartridge or CD/Media Player.

wDIGITAL IN 1, 2, 3, 4 input terminals

These are used to connect the digital output terminals of CD/Media Players and digital players.

eCOAXIAL DIGITAL OUT terminal (44.1/ 48/ 96kHz)

Output from this RCA terminal is the digital output data. These signals are not affected by the master level adjustments. We recommend using an RCA cable designed for digital signals (75 ohms). (This can be purchased from an audio/video store.)

rLINE 1, 2, 3, 4 FADER output terminals

Connect these terminals to the Fader input terminals of the DN-S1200, DN-S3700 and etc using the 3.5 mm stereo mini cord.

tUSB B terminal

This is connected to a computer to send and receive the USB MIDI, HID and USB audio signals.

The terminal supports USB 2.0 HighSpeed.

Only one mass storage device such as a USB memory or USB hard disk drive can be connected to this terminal.

(* A USB hub is not supported.)

The terminal supports USB 2.0 HighSpeed.

uMIDI output terminal

5-pin DIN connector output

This is connected to a MIDI-compatible device.

iREC OUT terminals

These are the recording output terminals.

oMASTER OUT (UNBALANCED) terminals

•This stereo pair of RCA terminals provides a unbalanced line level output.

•Connect these terminals to the unbalanced analog input terminals on an ampliﬁer or console.

Q0MASTER OUT (BALANCED) connectors

•These XLR type connectors provide a balanced line level output.

•Connect these connectors to the balanced analog input connectors on an ampliﬁer or console.

•Pin layout: 1. GND, 2. Hot, 3. Cold

•Applicable connector: Cannon XLR-3-32 or equivalent.

TRS plug.