HOW to Change the Jack Panel Position

HOW TO CHANGE THE JACK PANEL POSITION

The I/O jack panel of the PMC-250 can be placed either on the top or back side of the unit. Please refer to following Fig.

Initially, the I/O panel is placed on the top-side. In case of changing the jack panel position to TYPE □B, please use following instructions.

●Remove 5 pieces of silver screw, which secure the PANEL ①.

●Remove 5 pieces of silver screw, which secure the PANEL ②.

CAUTION

Please ensure use of the proper screwdriver (3mm Phillips type). Please hold the screwdriver upright and turn slowly. Do not use excessive force, or it may damage the screw head.

●Install the PANEL○1 to the back side and secure it with 5 silver screws.

●Install the PANEL○2 to the top side and secure it with 5 silver screws.