Master Section, Microphone Section | Vestax PMC 250 instruction

uHI CUT (Fader type cut switch HI)

When this volume is set to bottom position, high frequency range is cut of completely regardless of the position of the HI level control. The HI level control knob becomes active when this volume is set to maximum（top）position.

oLOW CUT (Fader type cut switch LOW)

When this volume is set to bottom position, low frequency range is cut of completely regardless of the position of the LOW level control. The LOW level control knob becomes active when this volume is set to maximum（top）position.

iMID CUT (Fader type cut switch MID)

When this volume is set to bottom position, mid frequency range is cut of completely regardless of the position of the MID level control. The MID level control knob becomes active when this volume is set to maximum（top）position.

!0INPUT FADER

Used to adjust the input level of each program. Please replace with IF-250 when it is worn out, or with the optional rotary fader unit.

MASTER SECTION

PRO FESSIONAL MIXING CONTROLLER

+6 +3 +2 +1 0 -1 -2 -4 -7 -10 -20 -30 POWER -30 -20 -10 -7 -4 -2 -1 0 +1 +2 +3 +6

Lch PGM 1

AUX		METER SELECT
		MASTER	PGM
MIN	MAX
MASTER			BOOTH OUT
MIN	MAX	MIN	MAX

Rch PGM 2

!1POWER INDICATOR

The LED light when the power is on.

!2LED LEVEL METER

The bar graph level meters indicate the master output level（L channel and R channel）or input level of each program（program 1 and 2）.

!3METER SELECT

When this switch is set to MASTER, the bar- graph meter indicates the master output level（L channel and R channel）. When it is set to PGM, the left meter shows the input level of PGM1 and the right meter shows the input level of PGM2.

!4AUX (AUX level volume)

Used to adjust the Input level of AUX IN.

PGM 2 LEVEL

!5MASTER (MASTER level volume)

Adjusts the output level of LINE OUT and PA OUT.

!6BOOTH OUT

Adjusts the output level of BOOTH OUT.

!7CROSS FADER

The signal from PGM1 is output when the cross fader is set to the left side. The signal from PGM2 is heard when the cross fader is set to the right side. When the cross fader is set at centre position, both programs will be mixed and output at the same time. Please replace it with the CF-PCV when it is worn out.

MICROPHONE SECTION

MIC

INPUT

LEVEL

FILTER

MIN	MAX	MIN	MAX
18	19		20

!8MIC INPUT (Mic Input Jack)

Input jack for the microphone.

!9MIC LEVEL (Mic Level Volume)

Adjusts the input level of the microphone.

@0MIC FILTER (Mic Filter Volume)

Adjusts the cut off frequency of the microphone input. It is used to prevent low frequency noise such as breathing, vibration, etc.