Vestax PMC 250 owner manual A T U R E S

Page 4

15.Damage Requiring Service-Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power-supply cord or plug is damaged.

b.If liquid has been spilled or objects have fallen into the product.

c.If the product has been exposed to rain or water.

d.If the product dose not operate normally by following the operating instructions. Adjust only those controls that are coverd by the operating instructions as an improper adjustment of other, controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.

e.If the product has been dropped or cabinet has been damaged.

f.When the product exhibits a distinct change in performance this indicates need for service.

16.Replacement Parts-When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original parts. Unauthorized substitutions may result in fire, electric shock or other hazards.

17.Safety Check-Upon completion of any service or repairs to product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

18.Carts and Stands-The appliance should be used only with a cart stand that is recommended by manufacturer.

19.An appliance and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn.

F E A T U R E S

1.Three-band frequency isolators are provided on PGM1 and PGM2 . This allows DJs to boost / cut and eliminate individual frequency ranges for active mixing.

2.The worlds first fader-type kill switch enables smooth and dynamic frequency cut-off without clicking noise.

3.The I/O panel can be placed on either the rear or top side. This feature enables the PMC-250 to be used on the table or in a rack without any extra space for the leads.

4.Both the input faders60 mmand cross fader 45 mmare user replaceable. The input fader can be replaced with a rotary control for House

applications.

5.One Phono and two Line inputs are provided on each program channelPGM1, PGM2. Each input channel has a trim control for adjusting input level. A Phono / Line selectable AUX input and a Mic input are also provided.

3

Image 4
Contents Professional Mixing Controller Contents CONGRATULATIONS!Important Safeguards A D B E F O R E O P E R AT I N G E QU I P M E N TA T U R E S Program Section Master Section Microphone SectionMonitor Section Rear Panel SectionN N E C T I O N E X a M P L E TURNTABLE[VESTAX PDX-2000]TURNTABLE[VESHOW to Change the Fader Unit HOW to Change the Fader UnitHOW to Change the Jack Panel Position Block PGM-1Specification S