Hi RES Parameters Continued
Level 1, Output Setup Block Continued
Parameter | P# | Adjustable Range | Factory | User Setting |
OP1 | 1552 | 0-SPEED REF | 29 | |
ANAOUT1 | | 1-SPEED DEMAND | | |
Signal | | 2-ACC/DEC | | |
| | 3-MOT OR CURRENT | | |
| | 4-MAG CURRENT | | |
| | 5-MAG CURRENT | | |
| | COMMAND | | |
| | 6-LOAD CURRENT | | |
| | 7-LOAD CURRENT | | |
| | COMMAND | | |
| | 8-POWER | | |
| | 9-PH1 CURRENT | | |
| | 10-PH2 CURRENT | | |
| | 11-PH3 CURRENT | | |
| | 12-MOT OR VOLTAGE | | |
| | 13-VD DEMAND | | |
| | 14-VQ DEMAND | | |
| | 15-BUS VOLTAGE | | |
OP1 | 1555 | 29 | |
16-ABS TORQUE | |
ANAOUT2 | | 17-T ORQUE | | |
Signal | | 18-CONTROL TEMP | | |
| | 19-ANALOG INPUT1 | | |
| | 20-ANALOG INPUT2 | | |
| | 21-OPT1 ANA IN1 | | |
| | 22-OPT1 ANA IN2 | | |
| | 23-OPT2 ANA IN1 | | |
| | 24-OPT2 ANA IN2 | | |
| | 25-PROC FEEDFORWARD | | |
| | 26-PROC FEEDBACK | | |
| | 27-PROC SETPOINT | | |
| | 28-ELECTRIC ANGLE | | |
| | 29-ABS SPEED | | |
| | 30-VELOCITY | | |
| | 31-NETWORK | | |
| | 32-CALIBRA TE | | |
| | | | |
OP1 parameter selections (P#1551 to 1556) are available if the expansion board is installed in Slot1 of the Control.
