Meyer Sound Matrix3 manual Reference, First Row of LEDs, First Row of Buttons

Page 24

Reference

Reference

The following section provides details for each, LED, button and feature found on the CueMixer.

First Row of LEDs

The mode LEDs are used to indicate the active mode. When using the CueMixer along with a computer you will see the active mode as the top window on the computer monitor (IF you have Enabled “Window Follow” for the CueMixer). The mode indicates what the faders are controlling.

System

System Level (Auto) and Manual System Level (Manual) faders active.

Trims

The Trims LED is used to show that Trims has been toggled ON. Input Trims trims and Output trims are displayed by using both the Trims LED and the respective Input /Output LEDs. If you toggle Trims ON, then try to select a mode that does not have trims. The CueMixer will not change to that mode until you toggle Trims OFF.

Inputs

Console Input faders active.

Bus Levels

Bus Level faders active.

Outputs

Output Master faders active.

Aux Out

Aux Output Master faders active.

GO

The eighth LED is on all of the time. It is used as a visual target for the GO button.

First Row of Buttons

System Master

This button gives instant access to the Automated System Level (fader 1) and the Manual System Level (fader 2).

Important

Aux Outputs are PRE-System Master (i.e. pulling the Master faders down will not silence the Aux Outputs).

Trims

The Trims button is a toggle, selecting between Inputs (trim), Bus Levels (trim), or Outputs (trim). This is displayed by having both the Trims LED on and the selected mode LED on. If you toggle Trims ON, then try to select a mode that does not have trims, the CueMixer will not change mode.

STOP

Stops scheduler, trajectory, Wild Tracks playback, and pending cues and subcues.

<

Return to Beginning. This is the return to the top of the Cue List function for the transport window.

<< Skip

The same as stepping to a lower numbered cue in the Cue List in the transport window.

>> Skip

The same as stepping to a higher numbered cue in the Cue List in the transport window.

24

Image 24
Contents CueMixer Matrix3 Audio Show Control SystemPage Page Page Table of Contents Page CueMixer Setup Connecting the CueMixerRS-422 Serial Cable DIP Switch Settings CueMixer RS-422 ConnectionPinPurpose Page CueMixer Controls System MasterShift Mode ModesSelect CueMixer Shift ExamplesTransport Buttons Channel PagesReturn to Start Skip BackIsolate MuteUser Buttons CueMixer Setup Programming CueMixer FunctionsEnable Console Modes Enable EQ/Trim ModesEnable Misc Console Modes Assign User A/B CuesEnable Cue 0 CueMixer Set ModeButton Overlay Button DebounceUser a Mode User a Mode SelectUser a Mode Print Button Assignments Set Port on LX-300Page Using the CueMixer Mixing with Virtual GroupsExecuting Cues with User a Buttons Page CueMixer Details Basic OperationChanging Reference First Row of LEDsFirst Row of Buttons Second Row of LEDs Second Row of ButtonsWhen EQ is Active EQ Fader FunctionsFader Fader Function Mute Function Third Row of LEDs Third Row of ButtonsFourth Row of LEDs Fourth Row of ButtonsPage Service and Troubleshooting ServiceTroubleshooting Problem SolutionVerification and Minor Adjustment Fader CreepTrim Adjustment Locations Board T1 Fader Resetting Trim Adjustments Fader Board