Meyer Sound Matrix3 manual Trim Adjustment Locations

Page 31

Calibration

Trim Adjustment Locations

DB-9

CPU

Board T1

Fader

Board

T1

Resetting Trim Adjustments

Fader Board

T1

If minor adjustments do not align the faders, or if the trim adjustments are too far out of range, you can start over using the following steps:

1.In CueStation, set Inputs 1 to 8 to –25.0

2.Use Fader Board T1 to adjust each set of four faders to align with –25 on the front panel.

3.In CueStation, set Inputs 1 to 8 to 0.0

4.Use CPU T1 to adjust all eight faders to align with +0 on the front panel.

5.In CueStation, set Inputs 1 to 8 to +0 (Unity.)

6.Repeat steps 1 to 5 several times to converge adjustments. Each cycle should require a smaller adjustment. (Note that there is a large null area in the adjustment of CPU T1.)

7.In CueStation, set Inputs 1 to 8 to –Infinity. If necessary make a small adjustment to Fader Board T1 keep any fader from hitting the end stop and clicking.

8.In CueStation, Set Inputs 1 to 8 to +10.0. If necessary make a small adjustment to CPU T1 to keep any fader from hitting the end stop and clicking.

9.Test the faders for creep. If the faders creep up in value, adjust CPU T1 clock-wise. If the faders creep down in value, adjust the CPU T1 counter-clock-wise.

10.In CueStation, set Inputs 1 to 8 to –25.0 and verify that the faders are all aligned within 3mm. If not, go to step 1 and start over.

31

Image 31
Contents Matrix3 Audio Show Control System CueMixerPage Page Page Table of Contents Page Connecting the CueMixer CueMixer SetupRS-422 Serial Cable CueMixer RS-422 Connection DIP Switch SettingsPinPurpose Page System Master CueMixer ControlsCueMixer Shift Examples Shift ModeModes SelectSkip Back Transport ButtonsChannel Pages Return to StartMute IsolateUser Buttons Programming CueMixer Functions CueMixer SetupEnable EQ/Trim Modes Enable Console ModesAssign User A/B Cues Enable Misc Console ModesButton Debounce Enable Cue 0 CueMixerSet Mode Button OverlaySet Port on LX-300 User a ModeUser a Mode Select User a Mode Print Button AssignmentsPage Mixing with Virtual Groups Using the CueMixerExecuting Cues with User a Buttons Page Basic Operation CueMixer DetailsChanging First Row of LEDs ReferenceFirst Row of Buttons Second Row of Buttons Second Row of LEDsEQ Fader Functions When EQ is ActiveFader Fader Function Mute Function Fourth Row of Buttons Third Row of LEDsThird Row of Buttons Fourth Row of LEDsPage Problem Solution Service and TroubleshootingService TroubleshootingFader Creep Verification and Minor AdjustmentBoard T1 Fader Resetting Trim Adjustments Fader Board Trim Adjustment Locations