Meyer Sound Matrix3 manual RS-422 Serial Cable

Page 8

 

Connecting the CueMixer

CueMixer

LX-COS module

 

Port B

RS-422

RS-422 Serial Cable

On the Matrix3 LX-COS module, Port A and Port B use the same connector pin-outs as the CueMixer, so the cable connections are swapped from end to end. The cable needed to connect the LX-COS module to the CueMixer should be wired as shown.

Use a two-shielded-pair stranded cable with low capacitance. Pins 4&5 are one pair, and 8&9 are the second pair. (See the appendix for an application note on how to use two channels in an audio snake to run the CueMixer signal.)

8

Image 8
Contents CueMixer Matrix3 Audio Show Control SystemPage Page Page Table of Contents Page CueMixer Setup Connecting the CueMixerRS-422 Serial Cable PinPurpose DIP Switch SettingsCueMixer RS-422 Connection Page CueMixer Controls System MasterShift Mode ModesSelect CueMixer Shift ExamplesTransport Buttons Channel PagesReturn to Start Skip BackUser Buttons IsolateMute CueMixer Setup Programming CueMixer FunctionsEnable Console Modes Enable EQ/Trim ModesEnable Misc Console Modes Assign User A/B CuesEnable Cue 0 CueMixer Set ModeButton Overlay Button DebounceUser a Mode User a Mode SelectUser a Mode Print Button Assignments Set Port on LX-300Page Executing Cues with User a Buttons Using the CueMixerMixing with Virtual Groups Page Changing CueMixer DetailsBasic Operation First Row of Buttons ReferenceFirst Row of LEDs Second Row of LEDs Second Row of ButtonsFader Fader Function Mute Function When EQ is ActiveEQ Fader Functions Third Row of LEDs Third Row of ButtonsFourth Row of LEDs Fourth Row of ButtonsPage Service and Troubleshooting ServiceTroubleshooting Problem SolutionVerification and Minor Adjustment Fader CreepTrim Adjustment Locations Board T1 Fader Resetting Trim Adjustments Fader Board