Input

To use Speaker Level Inputs (common ground head units only), connect RCA plugs to the front or rear speaker leads as shown.

NOTE: It is important to connect an input signal to both RCA input jacks if a stereo amplifier is used, otherwise the connected channel receives full range and the disconnected channel will receive only the harmonics.

Use a RCA female to dual male “Y” cord if mono input is used.

In-dash

CD Receiver

Front Rear

Maxx

Bass®

Power

Amplifiers

Front speakers

LF with Virtual RF SubwooferTM

LRRR

Subwoofer

WARNING: If you are using a source unit with bridged high powered (or "floating ground") speaker outputs, a suitable high to low level adapter must be used. If you are unsure about your head unit see your local PrecisionPowerTM dealer.