Specifications

Frequency	20hz-20kHz
Signal-to-Noise Ratio	>85dB
Separation	65dB @ 1kHz
Crossover Slope	24dB/octave
Input Impedance	20,000 Ohms
Input Sensitivity	variable, 300mV to 3V peak to peak
Output Level	variable, 300mV to 5V peak to peak
Supply Voltage	9 to 16 VDC
INSTALLATION/MOUNTING

NOTE: As an option, before beginning, disconnect the negative (-) terminal of the battery to prevent an electrical short to ground. Reconnect the negative terminal only after all connections have been made.

To prevent damage to the MaxxBass® Processor while driving, mount in a secure place. Choosing the appropriate location will depend upon your vehicle and the complexity of your system design. Typical mounting locations include the trunk and passenger compartment (floor or under seat). Never mount the MaxxBass® Processor in a location that would subject it to immersion or exposure to water.

Once a location has been chosen, securely mount the MaxxBass® Processor with the four mounting screws. Be Careful! Inspect the area underneath to be sure you are not drilling into wires, brake or fuel lines, etc. that could be damaged by the drill bits or screws.