Stow manual Stow MS-70 PLASTER/MORTAR Mixer Electric Motor, Electric Motor Connection

STOW MS-70 PLASTER/MORTAR MIXER — ELECTRIC MOTOR

Electric Motor

For maintenance care and operation of the electric motor, refer to your electric motor instruction booklet furnished with the motor.

Protect the electric motor from dust as much as possible and keep ventilating openings clean.

CAUTION	Electric Motor
	Safety

DO NOT spray water at any time on the electric motor.

DO NOT operate electric motor in a explosive environment.

The electric motor used in this mixer is a single-phase 3 HP motor. The input voltage requirement for this motor is 115/230 VAC, and has been pre-set to 230VAC.

Electric Motor Connection

A12-inch electrical cable (Figure 7) is provided with the electrical motor for hookup to a power source.Table 5 shows the required NEMA connector for the desired motor horsepower rating. In addition, Table 5 also shows the matching NEMA approved connector for the required extension cord.

CAUTION	Electric Motor
	Connections

TABLE 5. ELECTRIC MOTOR WIRING INFORMATION

Motor		115-230 VAC - Single Phase
Horsepower	NEMA Plug Connector				Mating NEMA
Rating
			Receptacle Connector
1.5 HP	L5-20P P/N EM940537		L5-20R P/N EM940538
(115 VAC)
1.5 HP	L6-20P P/N 940539			L6-20R P/N 940540
(230 VAC)

ALWAYS make certain that the power source required for the electric motor is correct and always use the correct NEMA configuration plug. Failure to supply the correct voltage to the motor can severely damage the motor.

It is strongly recommended that all

NOTE electrical wiring be done by a licensed electrician.

Special attention should be given to the electric switch as well as the over-and-under voltage protection devices as per regulations set forth in the local electrical safety code handbook

Figure 7. Single Phase Electric Motor With

12-inch Pigtail

PAGE 18 — STOW MS-70 MIXER — OPERATION MANUAL — REV. #3 (03/26/10)